[PATCH v11 4/4] G45 TWI: remove open drain setting for twi function gpios

[ludovic.desroches@atmel.com (ludovic.desroches)]

Le 08/27/2012 03:22 PM, Voss, Nikolaus a ?crit :
> Hi Ludovic,
>
> ludovic.desroches wrote on Monday, August 27, 2012 12:25 PM:
>> Le 11/08/2011 12:11 PM, Nikolaus Voss a ?crit :
>>> The G45 datasheets explicitly states that setting the open drain property
>>> on peripheral function gpios is not allowed. (How about other A91 chips?)
>>
>> Did you remove open drain because you had some issues or because you
>> had  seen it into datasheet?
>>
>> I tried with and without open drain. The behavior was the same. Looking
>> to the G45 datasheet, I didn't see that the open drain property is not
>> allowed on peripheral function gpios:
>>
>> 'The Multi Drive can be selected whether the I/O line
>> is controlled by the PIO controller or assigned to a peripheral function.'
>>
>> The datasheet should have been updated or there is another place where
>> it is mentioned that open drain property is not allowed in this case.
>
> well, it didn't work on my G45. I found the following note in the
> TWI chapter 31.6.1 of the G45 datasheet:
> "The user must not program TWD and TWCK as open-drain.
> It is already done by the hardware."

Ok so it seems there is a contradiction. I'll try to inquire about this 
point.

Regards

Ludovic

>
> After removing the open-drain setting, it worked.
>
> Regards,
> Nikolaus
>
>
>
>