From mboxrd@z Thu Jan  1 00:00:00 1970
From: lauri.hintsala@bluegiga.com (Lauri Hintsala)
Date: Thu, 15 Nov 2012 09:22:39 +0200
Subject: [PATCH v2 2/3] serial: mxs-auart: add the DMA support for mx28
In-Reply-To: <50A45F83.1010009@freescale.com>
References: <1351074456-25863-1-git-send-email-b32955@freescale.com>
 <1351074456-25863-3-git-send-email-b32955@freescale.com>
 <50A21613.6030709@bluegiga.com> <50A45F83.1010009@freescale.com>
Message-ID: <50A4983F.8080407@bluegiga.com>
To: linux-arm-kernel@lists.infradead.org
List-Id: linux-arm-kernel.lists.infradead.org

Hi,

On 11/15/2012 05:20 AM, Huang Shijie wrote:
> ? 2012?11?13? 17:42, Lauri Hintsala ??:
>> Hi Huang,
>>
>> DMA support doesn't work with latest stable v3.6.5 or development
>> 3.7-rc5 kernels. I get following error message when I open the serial
>> port /dev/ttyAPP0:
>>
>> [ 48.730000] mxs-auart 8006a000.serial: step 1 error
>> [ 48.750000] mxs-auart 8006a000.serial: We can not start up the DMA.
>>
> I tested this patch set in imx28-evk board Rev C with linux-next-20121114.
> it works fine.
>
> Maybe you can try the linux-next code.

I tested linux-next-20121114 on apx4devkit (imx28 based device) and I 
got the same error message:

# stty -F /dev/ttyAPP0 crtscts; microcom /dev/ttyAPP0 -s 115200
[  133.710000] mxs-auart 8006a000.serial: step 1 error
[  133.720000] mxs-auart 8006a000.serial: We can not start up the DMA.


> About the flow control:
> If we do not enable the HW flow control, the data may lost. And I do not
> know how to handle with the Xon/Xoff when the DMA is supported.

I do not have the answer but it is already implemented in Freescale's 
reference kernel 
(http://git.freescale.com/git/cgit.cgi/imx/linux-2.6-imx.git/tree/drivers/serial/mxs-auart.c?h=imx_2.6.35_11.09.01). 
So I think it is possible to handle all data without HW flow control.


Best Regards,
Lauri Hintsala