From mboxrd@z Thu Jan  1 00:00:00 1970
From: grinberg@compulab.co.il (Igor Grinberg)
Date: Mon, 07 Jan 2013 17:28:22 +0200
Subject: [PATCH 1/4] ALSA: pxa2xx: fix ac97 cold reset
In-Reply-To: <50EAD983.5060801@newsguy.com>
References: <1357499640-13871-1-git-send-email-mikedunn@newsguy.com>
 <1357499640-13871-2-git-send-email-mikedunn@newsguy.com>
 <50EA9287.5030304@compulab.co.il> <50EACF4D.4000602@newsguy.com>
 <50EAD43C.2040406@compulab.co.il> <50EAD983.5060801@newsguy.com>
Message-ID: <50EAE996.8080401@compulab.co.il>
To: linux-arm-kernel@lists.infradead.org
List-Id: linux-arm-kernel.lists.infradead.org

On 01/07/13 16:19, Mike Dunn wrote:
> On 01/07/2013 05:57 AM, Igor Grinberg wrote:
>> On 01/07/13 15:36, Mike Dunn wrote:
>>> On 01/07/2013 01:16 AM, Igor Grinberg wrote:
>>>> On 01/06/13 21:13, Mike Dunn wrote:
>>>
>>>
>>> [..]
>>>
>>>
>>>>>  static inline void pxa_ac97_cold_pxa27x(void)
>>>>>  {
>>>>> +	unsigned int timeout;
>>>>> +
>>>>>  	GCR &=  GCR_COLD_RST;  /* clear everything but nCRST */
>>>>>  	GCR &= ~GCR_COLD_RST;  /* then assert nCRST */
>>>>>  
>>>>> @@ -157,8 +159,10 @@ static inline void pxa_ac97_cold_pxa27x(void)
>>>>>  	clk_enable(ac97conf_clk);
>>>>>  	udelay(5);
>>>>>  	clk_disable(ac97conf_clk);
>>>>> -	GCR = GCR_COLD_RST;
>>>>> -	udelay(50);
>>>>> +	GCR = GCR_COLD_RST | GCR_WARM_RST;
>>>>> +	timeout = 100;     /* wait for the codec-ready bit to be set */
>>>>> +	while (!((GSR | gsr_bits) & (GSR_PCR | GSR_SCR)) && timeout--)
>>>>> +		mdelay(1);
>>>>
>>>> Can we use msleep() instead?
>>>> May be this will require to change the granularity to 10...
>>>
>>>
>>> Probably.  mdelay() is used by similiar code in the same file, so I just stayed
>>> consistent.  The code runs very infrequently, so I didn't worry about it.
>>
>> Well, if we can, I think we'd better do, no?
> 
> 
> If you feel strongly about it, I'll defer to you.  But again my arguments are
> (1) the code runs very infrequently, and (2) very similar code for the other pxa
> family siblings uses mdelay().

No, not too strong, but please, don't argument your code with something like:
"there are other places where this is done", because it might be done
improperly and just go in unnoticed.


-- 
Regards,
Igor.