[PATCH 02/13] USB: phy: nop: Defer probe if device needs VCC/RESET

[kishon@ti.com (kishon)]

On Monday 04 February 2013 09:28 PM, Roger Quadros wrote:
> Add 2 flags, needs_vcc and needs_reset to platform data.
> If the flag is set and the regulator couldn't be found
> then we bail out with -EPROBE_DEFER.
>
> For device tree boot we depend on presensce of vcc-supply/
> reset-supply properties to decide if we should bail out
> with -EPROBE_DEFER or just continue in case the regulator
> can't be found.
>
> This is required for proper functionality in cases where the
> regulator is needed but is probed later than the PHY device.
>
> Signed-off-by: Roger Quadros <rogerq@ti.com>
> ---
>   drivers/usb/otg/nop-usb-xceiv.c   |    8 ++++++++
>   include/linux/usb/nop-usb-xceiv.h |    4 ++++
>   2 files changed, 12 insertions(+), 0 deletions(-)
>
> diff --git a/drivers/usb/otg/nop-usb-xceiv.c b/drivers/usb/otg/nop-usb-xceiv.c
> index adbb7ab..7860e7569 100644
> --- a/drivers/usb/otg/nop-usb-xceiv.c
> +++ b/drivers/usb/otg/nop-usb-xceiv.c
> @@ -147,6 +147,10 @@ static void nop_xeiv_get_dt_pdata(struct device *dev,
>
>   	if (!of_property_read_u32(node, "clock-frequency", &clk_rate))
>   		pdata->clk_rate = clk_rate;
> +	if (of_property_read_bool(node, "vcc-supply"))
> +		pdata->needs_vcc = true;
This can be written as..
pdata->needs_vcc = of_property_read_bool(node, "vcc-supply");

> +	if (of_property_read_bool(node, "reset-supply"))
> +		pdata->needs_reset = true;
same here..
>   }
>
>   static int nop_usb_xceiv_probe(struct platform_device *pdev)
> @@ -205,12 +209,16 @@ static int nop_usb_xceiv_probe(struct platform_device *pdev)
>   	if (IS_ERR(nop->vcc)) {
>   		dev_dbg(&pdev->dev, "Error getting vcc regulator: %ld\n",
>   					PTR_ERR(nop->vcc));
> +		if (pdata->needs_vcc)
> +			return -EPROBE_DEFER;
>   	}
>
>   	nop->reset = devm_regulator_get(&pdev->dev, "reset");
>   	if (IS_ERR(nop->reset)) {
>   		dev_dbg(&pdev->dev, "Error getting reset regulator: %ld\n",
>   					PTR_ERR(nop->reset));
> +		if (pdata->needs_reset)
> +			return -EPROBE_DEFER;
>   	}
>
>   	nop->dev		= &pdev->dev;
> diff --git a/include/linux/usb/nop-usb-xceiv.h b/include/linux/usb/nop-usb-xceiv.h
> index 3265b61..148d351 100644
> --- a/include/linux/usb/nop-usb-xceiv.h
> +++ b/include/linux/usb/nop-usb-xceiv.h
> @@ -6,6 +6,10 @@
>   struct nop_usb_xceiv_platform_data {
>   	enum usb_phy_type type;
>   	unsigned long clk_rate;
> +
> +	/* if set fails with -EPROBE_DEFER if can't get regulator */
> +	unsigned int needs_vcc:1;
> +	unsigned int needs_reset:1;

how about u8 here?

Thanks
Kishon