From mboxrd@z Thu Jan 1 00:00:00 1970 From: santosh.shilimkar@ti.com (Santosh Shilimkar) Date: Tue, 19 Mar 2013 14:21:19 +0530 Subject: OMAP baseline test results for v3.9-rc3 In-Reply-To: References: Message-ID: <51482707.6020501@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org + Tero, On Monday 18 March 2013 09:08 PM, Paul Walmsley wrote: > > Here are some basic OMAP test results for Linux v3.9-rc3. > Logs and other details at: > > http://www.pwsan.com/omap/testlogs/test_v3.9-rc3/20130314094808/ > > > Test summary > ------------ > Thanks for the summary Paul. A usual, it is quite exhaustive. Few questions and comments below. [..] > Failing tests: needing investigation > ------------------------------------ > [..] > PM tests: > [..] > > * 4430es2panda, 4460pandaes: pwrdm state mismatch on CAM, DSS, ABE > I thought we discussed about boot-loader dependency already. > * 4460pandaes: pwrdm state mismatch on IVAHD, TESLA > Same here. > * 4430es2panda: CORE, TESLA, IVAHD, L3INIT didn't enter target state > - Probably due to lack of reset code for M3, DSP, SL2IF, FSUSB > per discussion with Tero Kristo > - Likely dependent on the bootloader version > - fails with 2012.07-00136-g755de79 > Do you still see the issue after upgrading the boot-loader version ? > * 4460pandaes: chip not entering retention in dynamic idle > - Presumably 4430es2panda also fails this > - Suspend-to-RAM enters full chip retention > Assuming dynmic idle is CPUIdle, core retention isn't supported in CPUDILE so it is expected > > Other: > > * 4430es2panda: omap_hwmod: l3_instr: _wait_target_disable failed > - Unknown cause; could be due to the lack of hierarchical enable/disable > in hwmod code > - Jon Hunter reports this does not appear with the same X-loader/bootloader > on his 4430ES2.3 Panda, so could be ES-level dependent I confirm Jon's observation even on my OMAP4430 ES2.3 SDP. Regards, Santosh