From mboxrd@z Thu Jan  1 00:00:00 1970
From: sebastian.hesselbarth@gmail.com (Sebastian Hesselbarth)
Date: Mon, 20 May 2013 23:38:00 +0200
Subject: [PATCH v3 6/7] ARM: kirkwood: add gigabit ethernet and mvmdio
 device tree nodes
In-Reply-To: <20130520212708.GA26519@schnuecks.de>
References: <1365071235-11611-1-git-send-email-florian@openwrt.org>
 <1367854420-8006-1-git-send-email-sebastian.hesselbarth@gmail.com>
 <1367854420-8006-7-git-send-email-sebastian.hesselbarth@gmail.com>
 <20130520212708.GA26519@schnuecks.de>
Message-ID: <519A97B8.1090503@gmail.com>
To: linux-arm-kernel@lists.infradead.org
List-Id: linux-arm-kernel.lists.infradead.org

On 05/20/2013 11:27 PM, Simon Baatz wrote:
> Hi Sebastian,
>
> On Mon, May 06, 2013 at 05:33:39PM +0200, Sebastian Hesselbarth wrote:
>> This patch adds mv643xx_eth and mvmdio device tree nodes for DT enabled
>> Kirkwood boards. Phy nodes are also added with reg property set on a
>> per-board basis.
> ...
>> diff --git a/arch/arm/boot/dts/kirkwood.dtsi b/arch/arm/boot/dts/kirkwood.dtsi
>> index fada7e6..c01a273 100644
>> --- a/arch/arm/boot/dts/kirkwood.dtsi
>> +++ b/arch/arm/boot/dts/kirkwood.dtsi
>> @@ -202,5 +202,57 @@
>>   			clocks =<&gate_clk 4>;
>>   			status = "disabled";
>>   		};
>> +
>> +		mdio: mdio-bus at 72004 {
>> +			compatible = "marvell,orion-mdio";
>> +			reg =<0x72004 0x84>;
>> +			interrupts =<11>;
>
> Shouldn't this be 46?

Yes, mdio is using GbE0Err interrupt and that is 14 on IRQ HIGH CAUSE.
I was misled by 11 on IRQ LOW CAUSE.

Sebastian