From mboxrd@z Thu Jan 1 00:00:00 1970 From: sebastian.hesselbarth@gmail.com (Sebastian Hesselbarth) Date: Wed, 22 May 2013 23:17:46 +0200 Subject: [PATCH v4 11/12] ARM: kirkwood: remove redundant DT board files In-Reply-To: <20130522210257.GM31290@titan.lakedaemon.net> References: <1367854420-8006-1-git-send-email-sebastian.hesselbarth@gmail.com> <1369154510-4927-1-git-send-email-sebastian.hesselbarth@gmail.com> <1369154510-4927-12-git-send-email-sebastian.hesselbarth@gmail.com> <20130522203633.GA28394@schnuecks.de> <519D30CF.9040904@gmail.com> <20130522210257.GM31290@titan.lakedaemon.net> Message-ID: <519D35FA.2060002@gmail.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 05/22/2013 11:02 PM, Jason Cooper wrote: > On Wed, May 22, 2013 at 10:55:43PM +0200, Sebastian Hesselbarth wrote: >> On 05/22/2013 10:36 PM, Simon Baatz wrote: >>> Hi Sebastian, >>> >>> On Tue, May 21, 2013 at 06:41:49PM +0200, Sebastian Hesselbarth wrote: >>>> With DT support for mv643xx_eth, board specific init for some boards now >>>> is unneccessary. Remove those board files, Kconfig entries, and >>>> corresponding entries in kirkwood_defconfig. >>>> >>>> Signed-off-by: Sebastian Hesselbarth >>>> --- >>>> Note: board-km_kirkwood.c is also removed, as Valentin Longchamp confirmed >>>> the lock-up is not caused by accessing clock gating registers but rather >>>> non-existent device registers. This will be addressed by dtsi separation >>>> for kirkwood and bobcat SoC variants. >>>> >>>> Changelog: >>>> v3->v4: >>>> - remove more boards that don't require board specific setup >>>> >> ... >> >> I would stick with "marvell,kirkwood" only. This is SoC init code and >> we do not distinguish variants here at all. > > Agreed, nice catch Simon. I just confirmed all kirkwood dts/dtsi properly set "marvell,kirkwood" in their compatible strings. Will remove all other comapatible strings from mach-kirkwood/board-dt.c as Simon suggested for v5. Sebastian