From mboxrd@z Thu Jan 1 00:00:00 1970 From: tushar.behera@linaro.org (Tushar Behera) Date: Thu, 06 Jun 2013 14:37:01 +0530 Subject: [PATCH v2 1/3] ARM: EXYNOS: uncompress - print debug messages if DEBUG_LL is defined In-Reply-To: <1370319552-17694-2-git-send-email-tushar.behera@linaro.org> References: <1370319552-17694-1-git-send-email-tushar.behera@linaro.org> <1370319552-17694-2-git-send-email-tushar.behera@linaro.org> Message-ID: <51B05135.3020006@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 06/04/2013 09:49 AM, Tushar Behera wrote: > Printing low-level debug messages make an assumption that the specified > UART port has been preconfigured by the bootloader. Incorrectly > specified UART port results in system getting stalled while printing the > message "Uncompressing Linux... done, booting the kernel" > This UART port number is specified through S3C_LOWLEVEL_UART_PORT. Since > the UART port might different for different board, it is not possible to > specify it correctly for every board that use a common defconfig file. > > Calling this print subroutine only when DEBUG_LL fixes the problem. By > disabling DEBUG_LL in default config file, we would be able to boot > multiple boards with different default UART ports. > > With this current approach, we miss the print "Uncompressing Linux... > done, booting the kernel." when DEBUG_LL is not defined. > > Signed-off-by: Tushar Behera > --- > Change for v2: > * Instead of checking value of uart_base, now check if DEBUG_LL > is enabled. This removes the ifdef's from mach/uncompress.h > > > arch/arm/plat-samsung/include/plat/uncompress.h | 10 +++++++++- > 1 file changed, 9 insertions(+), 1 deletion(-) > If there are no concerns, would it be possible to queue this patch [1/3] for 3.10? The other two patches can wait for 3.11. -- Tushar Behera