[PATCH v6 5/7] ARM: kirkwood: remove redundant DT board files

[sebastian.hesselbarth@gmail.com (Sebastian Hesselbarth)]

On 07/03/13 01:09, Arnaud Ebalard wrote:
> Hi Sebastian,
>
> Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com> writes:
>
>> With DT support for mv643xx_eth board specific init for some boards now
>> is unneccessary. Remove those board files, Kconfig entries, and
>> corresponding entries in kirkwood_defconfig.
>
> Applying above your set an old quilt cleaning patch Jason asked at some
> point, it became empty except for arch/arm/mach_kirkwood/common.h in
> which some declarations were left behind. If this is correct, can you
> just merge the hunks below in your 5/7 in next round?
>
> AFAICT, only dnskw_init() remains, which matches the list of board-*.c
> files in arch/arm/mach_kirkwood/ (i.e. board-dt.c and board-dnskw.c).

While updating the patch with yours, I stumbled upon MACH_TS219_DT that
also remains because it includes tsx1x-common.c.

I cannot recall if Jason or Andrew said something about removing it..

Sebastian