From mboxrd@z Thu Jan  1 00:00:00 1970
From: tibor@harsszegi.com (Tibor Harsszegi)
Date: Wed, 10 Jul 2013 19:15:37 +0200
Subject: NSA310 + DT
In-Reply-To: <51DD964C.7020200@harsszegi.com>
References: <51DC564A.8050002@harsszegi.com> <20130709193605.GC26223@lunn.ch>
 <20130709202143.GD26223@lunn.ch>
 <2544f179ed4349545a25aa60d52a664a@harsszegi.com>
 <20130710134119.GA30885@lunn.ch> <51DD8E8B.2040505@harsszegi.com>
 <20130710165342.GA31692@lunn.ch> <51DD926C.1010205@harsszegi.com>
 <51DD964C.7020200@harsszegi.com>
Message-ID: <51DD96B9.8030900@harsszegi.com>
To: linux-arm-kernel@lists.infradead.org
List-Id: linux-arm-kernel.lists.infradead.org

Ok, was too fast :(
After a reboot the LEDs are gone, all green :(

t.
> WTF. Andrew. It works COMPLETELY.
> The memory mapped GPIO was working from the .config (don't ask me how).
>
> * sensors
> * LEDs
> * bootup works
>
> Awesome work thanks a lot!!!!
>> Cool, keep you posted.
>>> On Wed, Jul 10, 2013 at 06:40:43PM +0200, Tibor Harsszegi wrote:
>>>> Hello Andrew,
>>>>
>>>> I did a:
>>>>
>>>> ARCH=arm CROSS_COMPILE=arm-linux-gnueabi- make clean
>>>> ARCH=arm CROSS_COMPILE=arm-linux-gnueabi- make kirkwood_defconfig
>>>> ARCH=arm CROSS_COMPILE=arm-linux-gnueabi- make zImage
>>>> ARCH=arm CROSS_COMPILE=arm-linux-gnueabi- make dtbs
>>>> cat arch/arm/boot/zImage arch/arm/boot/dts/kirkwood-nsa310-tdc.dtb 
>>>> > /tmp/X
>>>> mv /tmp/X arch/arm/boot/zImage
>>>> ARCH=arm CROSS_COMPILE=arm-linux-gnueabi- make uImage
>>>> ARCH=arm CROSS_COMPILE=arm-linux-gnueabi- make modules
>>>>
>>>> [attached .config]
>>>>
>>>> copied the uImage over the NSA310, rebooted.
>>>> Good news: console is back
>>> Great. Probably was OF_SERIAL_PLATFORM
>>>
>>>> Bad news: LEDs still don't work (all green), kernel stops (tried
>>>> forcing rootfstype=ext4, didn't help)
>>> Ah, O.k. EXT4 is not part of kirkwood_defconfig. Hence it cannot mount
>>> the root fs.
>>>
>>> Please could you use make menuconfig and include it into the kernel
>>> image. I will also update the patch later.
>>>
>>> LEDs are not working because the GPIO driver is not loading.
>>> I will see if i can spot an obvious typo etc.
>>>
>>>    Andrew
>>
>