From mboxrd@z Thu Jan  1 00:00:00 1970
From: d-gerlach@ti.com (Dave Gerlach)
Date: Mon, 12 Aug 2013 13:59:11 -0500
Subject: [PATCHv3 0/9] ARM: OMAP2+: AM33XX: Add suspend-resume support
In-Reply-To: <52077B26.1010103@gmail.com>
References: <1375811376-49985-1-git-send-email-d-gerlach@ti.com>
 <52077B26.1010103@gmail.com>
Message-ID: <5209307F.9000701@ti.com>
To: linux-arm-kernel@lists.infradead.org
List-Id: linux-arm-kernel.lists.infradead.org

On 08/11/2013 06:53 AM, Daniel Mack wrote:
> Hi Dave,
>
> Thanks a lot for your work on this.
>
> On 06.08.2013 19:49, Dave Gerlach wrote:
>> This is the third version of the patch series for adding basic suspend-resume
>> support for AM33XX, previously submitted by Vaibhav Bedia. This patchset
>> is based on 3.11-rc4 and depends on a forthcoming patchset from Suman Anna
>> that adds mailbox support for the wkup_m3. The patches at [1], [2], and [3] are
>> required for the pm code to properly suspend and resume.
>
> I applied your set and the one from Suman Anna, and with musb disabled
> and the firmware built from the sources you referenced, I'm able to put
> a custom AM33xx based board to suspend.
>
> The problem I currently face is that I can't make the board resume, as
> neither UART0 nor GPIO0 seem to work as wakeup source.

Did you apply the other patches that are mentioned besides Suman's 
series? The board will hang while suspending without these.

>
> Which wakeup source did you use in your tests?
>

Most of my verification was done with UART wakeup.

>
> Thanks,
> Daniel
>