[PATCHv3 0/9] ARM: OMAP2+: AM33XX: Add suspend-resume support

[zonque@gmail.com (Daniel Mack)]

Hi Dave,

On 12.08.2013 20:59, Dave Gerlach wrote:
> On 08/11/2013 06:53 AM, Daniel Mack wrote:

>> The problem I currently face is that I can't make the board resume, as
>> neither UART0 nor GPIO0 seem to work as wakeup source.
> 
> Did you apply the other patches that are mentioned besides Suman's 
> series? The board will hang while suspending without these.

Yes. However, just to make sure you referenced the correct patches - on
top of yours an Suman's set, I have:

  [PATCH 1/2] ARM: OMAP2+: hwmod: rt address space index for DT
  [PATCH 2/2] ARM: OMAP2+: hwmod: AM335x: fix cpgmac address space
  [PATCH 1/2] ARM: dts: add AM33XX EDMA support

The last one seems somewhat unrelated though.

However, I see an issue with the musb dsps glue. With the usb controller
disabled in DT, I also had to remove the usb_otg_hs entry from
am33xx_mod[] (pm33xx.c). When the usb controller is _enabled_, I get an
instant NULL pointer exception due to a rather obvious bug. I'll send
out a patch right now.

When I send the board to suspend (with USB disabled), the power
consumption drops significantly, and the output is:

# echo mem > /sys/power/state
[   93.001937] PM: Syncing filesystems ... done.
[   93.033591] Freezing user space processes ... (elapsed 0.002 seconds)
done.
[   93.048532] Freezing remaining freezable tasks ... (elapsed 0.002
seconds) done.
[   93.059277] PM: Sending message for entering DeepSleep mode
[   93.085368] PM: suspend of devices complete after 15.070 msecs
[   93.096671] PM: late suspend of devices complete after 5.122 msecs
[   93.108853] PM: noirq suspend of devices complete after 5.647 msecs


... but traffic on UART0 won't cause a resume.


I'll dig a little deeper now, but if you have any idea, please let me know.


Thanks,
Daniel