From mboxrd@z Thu Jan 1 00:00:00 1970 From: ben.dooks@codethink.co.uk (Ben Dooks) Date: Fri, 30 Aug 2013 19:50:15 +0100 Subject: [PATCH 08/19] highbank: enable big-endian In-Reply-To: References: <1377639509-22778-1-git-send-email-ben.dooks@codethink.co.uk> <1377639509-22778-9-git-send-email-ben.dooks@codethink.co.uk> Message-ID: <5220E967.6020902@codethink.co.uk> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 28/08/13 16:21, Rob Herring wrote: > On Tue, Aug 27, 2013 at 4:38 PM, Ben Dooks wrote: >> Apart from a xgmac driver issue, the highbank seems to work correctly in >> big-endian mode. Allow the selection of big-endian in the system. >> >> Signed-off-by: Ben Dooks >> --- >> arch/arm/mach-highbank/Kconfig | 1 + >> 1 file changed, 1 insertion(+) >> >> diff --git a/arch/arm/mach-highbank/Kconfig b/arch/arm/mach-highbank/Kconfig >> index cd9fcb1..4f57554 100644 >> --- a/arch/arm/mach-highbank/Kconfig >> +++ b/arch/arm/mach-highbank/Kconfig >> @@ -18,3 +18,4 @@ config ARCH_HIGHBANK >> select PL320_MBOX >> select SPARSE_IRQ >> select USE_OF >> + select ARCH_SUPPORTS_BIG_ENDIAN > > The select entries should be sorted. > > Rob Ok, will sort this out. -- Ben Dooks http://www.codethink.co.uk/ Senior Engineer Codethink - Providing Genius