[PATCH] at91: mmc: fix missing pinctrl in dt

[jiri.prchal@aksignal.cz (Jiří Prchal)]

OK.

Dne 19.9.2013 15:21, Nicolas Ferre napsal(a):
> On 17/09/2013 11:57, Jiri Prchal :
>> This patch adds pinctrl to soc dtsi file.
>>
>> Signed-off-by: Jiri Prchal <jiri.prchal@aksignal.cz>
>
>
> Jiri,
>
> I will rework your patch by splitting the two lines. This will allow us to be consistent with other AT91 SoC/boards
> Device Tree descriptions.
>
> +        pinctrl-names = "default";
>
> This one is going in the SoC file, like you did.
>
> +        pinctrl-0 = <&pinctrl_mmc0_slot0_clk_cmd_dat0>;
>
> This one is under the responsibility of the board itself. The reason behind this is that the dat0 line can be
> multiplexed on another pin.
>
> So, if you need a particular pinctrl configuration on the board side, please send another patch for this addition.
>
> Thanks bye,
>
>
>> ---
>>   arch/arm/boot/dts/at91sam9x5.dtsi |    2 ++
>>   1 file changed, 2 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/at91sam9x5.dtsi b/arch/arm/boot/dts/at91sam9x5.dtsi
>> index cf78ac0..c5d26b0 100644
>> --- a/arch/arm/boot/dts/at91sam9x5.dtsi
>> +++ b/arch/arm/boot/dts/at91sam9x5.dtsi
>> @@ -556,6 +556,8 @@
>>                   interrupts = <12 IRQ_TYPE_LEVEL_HIGH 0>;
>>                   dmas = <&dma0 1 AT91_DMA_CFG_PER_ID(0)>;
>>                   dma-names = "rxtx";
>> +                pinctrl-names = "default";
>> +                pinctrl-0 = <&pinctrl_mmc0_slot0_clk_cmd_dat0>;
>>                   #address-cells = <1>;
>>                   #size-cells = <0>;
>>                   status = "disabled";
>>
>
>