[RFC PATCH v2] ARM: at91: add support for Cosino board series by HCE Engineering

[nicolas.ferre@atmel.com (Nicolas Ferre)]

On 13/11/2013 18:46, Rodolfo Giometti :
> On Wed, Nov 13, 2013 at 06:34:30PM +0100, Nicolas Ferre wrote:
>> From: Rodolfo Giometti <giometti@linux.it>
>>
>> This patch adds the Cosino at91sam9g35 based CPU module and the
>> Cosino Mega 2560 extension board.
>>
>> Web site: http://www.cosino.it
>>
>> Signed-off-by: Rodolfo Giometti <giometti@linux.it>
>> [nicolas.ferre at atmel.com: adapted to newer kernel, modified commit message]
>> Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
>> ---
>> Rodolfo,
>>
>> Can you please review this adaptation of your previous patch to newer kernel.
>> I hope to integrate your board in upcoming 3.14.
>>
>> You will see that I addressed the remarks by Jean-Christophe and Russell (about
>> commit message). Please tell me if it is good on your side.
>
> I did some changes... attached are the correct patches.

Doing the diff between our patch I only seen a difference in nand binding:
nand-on-flash-bbt;
is present in my adaptation while it is not in yours but I do not think 
it is a problem to keep it.

> Here the changelog V1 -> V2:
>
> [Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>]
> * prefix "at91-" added
> * atmel,mux-mask stuff removed
> * "compatible" stuff is now on the same line for easy-grep(TM)
> * lcd binding dropped

Absolutely, I will add it to the commit log and integrate in the 
upcoming at91-3.14-dt branch.

Thanks for your quick feedback. Bye,
-- 
Nicolas Ferre