From: srinivas.kandagatla@st.com (srinivas kandagatla)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH v3 36/36] ARM: STi: Add support for the FSM Serial Flash Controller
Date: Mon, 2 Dec 2013 13:05:15 +0000 [thread overview]
Message-ID: <529C858B.1040601@st.com> (raw)
In-Reply-To: <1385727565-25794-37-git-send-email-lee.jones@linaro.org>
Hi Lee,
On 29/11/13 12:19, Lee Jones wrote:
> + /* FSM */
> + spifsm: spifsm at fe902000{
> + compatible = "st,spi-fsm", "simple-bus";
"simple-bus" is redundant here.
> + reg = <0xfe902000 0x1000>;
> + reg-names = "spi-fsm";
> + pinctrl-0 = <&pinctrl_fsm>;
> +
> + st,syscfg = <&syscfg_rear>;
> + st,boot-device-reg = <0x958>;
> + st,boot-device-spi = <0x1a>;
> +
> + status = "okay";
> + };
thanks,
srini
next prev parent reply other threads:[~2013-12-02 13:05 UTC|newest]
Thread overview: 77+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-11-29 12:18 [PATCH v3 00/36] mtd: st_spi_fsm: Add new driver Lee Jones
2013-11-29 12:18 ` [PATCH v3 01/36] mtd: st_spi_fsm: Allocate resources and register with MTD framework Lee Jones
2013-12-02 13:52 ` srinivas kandagatla
2013-12-10 18:47 ` Brian Norris
2013-12-10 20:46 ` Brian Norris
2013-12-11 8:48 ` Lee Jones
2013-12-11 9:37 ` Angus Clark
2013-12-11 18:01 ` Brian Norris
2013-11-29 12:18 ` [PATCH v3 02/36] mtd: st_spi_fsm: Supply all register address and bit logic defines Lee Jones
2013-11-29 12:18 ` [PATCH v3 03/36] mtd: st_spi_fsm: Initialise and configure the FSM for normal working conditions Lee Jones
2013-12-10 19:01 ` Brian Norris
2013-12-10 20:08 ` Brian Norris
2013-11-29 12:18 ` [PATCH v3 04/36] mtd: st_spi_fsm: Supply framework for device requests Lee Jones
2013-12-10 20:19 ` Brian Norris
2013-12-13 14:35 ` Angus Clark
2013-11-29 12:18 ` [PATCH v3 05/36] mtd: st_spi_fsm: Supply a method to read from the FSM's FIFO Lee Jones
2013-11-29 12:18 ` [PATCH v3 06/36] mtd: st_spi_fsm: Supply defines for the possible flash command opcodes Lee Jones
2013-11-29 12:18 ` [PATCH v3 07/36] mtd: st_spi_fsm: Add support for JEDEC ID extraction Lee Jones
2013-11-29 12:18 ` [PATCH v3 08/36] mtd: devices: Provide header for shared OPCODEs and SFDP commands Lee Jones
2013-12-10 21:48 ` Brian Norris
2013-12-10 22:23 ` Brian Norris
2013-12-13 15:46 ` Angus Clark
2013-12-13 15:06 ` Angus Clark
2013-11-29 12:18 ` [PATCH v3 09/36] mtd: st_spi_fsm: Provide device look-up table Lee Jones
2013-12-10 22:03 ` Brian Norris
2013-12-17 9:17 ` Angus Clark
2014-01-07 16:11 ` Lee Jones
2013-11-29 12:18 ` [PATCH v3 10/36] mtd: st_spi_fsm: Dynamically setup flash device based on JEDEC ID Lee Jones
2013-11-29 12:19 ` [PATCH v3 11/36] mtd: st_spi_fsm: Search for preferred FSM message sequence configurations Lee Jones
2013-12-11 1:06 ` Brian Norris
2013-12-17 9:57 ` Angus Clark
2013-12-17 10:46 ` Lee Jones
2013-12-17 10:56 ` Angus Clark
2013-11-29 12:19 ` [PATCH v3 12/36] mtd: st_spi_fsm: Fetch platform specific configurations Lee Jones
2013-11-29 12:19 ` [PATCH v3 13/36] mtd: st_spi_fsm: Prepare the read/write FSM message sequence(s) Lee Jones
2013-11-29 12:19 ` [PATCH v3 14/36] mtd: st_spi_fsm: Add device-tree binding documentation Lee Jones
2013-11-29 19:07 ` Linus Walleij
2013-12-02 11:03 ` Lee Jones
2013-12-03 10:23 ` Linus Walleij
2013-12-03 11:31 ` Lee Jones
2013-12-03 12:22 ` Linus Walleij
2013-12-03 12:31 ` Lee Jones
2013-11-29 12:19 ` [PATCH v3 15/36] mtd: st_spi_fsm: Fetch boot-device from mode pins Lee Jones
2013-12-11 1:27 ` Brian Norris
2013-11-29 12:19 ` [PATCH v3 16/36] mtd: st_spi_fsm: Provide the erase one sector sequence Lee Jones
2013-11-29 12:19 ` [PATCH v3 17/36] mtd: st_spi_fsm: Provide the sequence for enabling 32bit addressing mode Lee Jones
2013-11-29 12:19 ` [PATCH v3 18/36] mtd: st_spi_fsm: Prepare read/write sequences according to configuration Lee Jones
2013-11-29 12:19 ` [PATCH v3 19/36] mtd: st_spi_fsm: Add a check to if the chip can handle an SoC reset Lee Jones
2013-11-29 12:19 ` [PATCH v3 20/36] mtd: st_spi_fsm: Provide a method to put the chip into 32bit addressing mode Lee Jones
2013-12-11 1:49 ` Brian Norris
2013-11-29 12:19 ` [PATCH v3 21/36] mtd: st_spi_fsm: Update the flash Volatile Configuration Register Lee Jones
2013-11-29 12:19 ` [PATCH v3 22/36] mtd: st_spi_fsm: Provide the default read/write configurations Lee Jones
2013-12-11 1:37 ` Brian Norris
2013-11-29 12:19 ` [PATCH v3 23/36] mtd: st_spi_fsm: Supply the N25Qxxx specific read configurations Lee Jones
2013-11-29 12:19 ` [PATCH v3 24/36] mtd: st_spi_fsm: Supply the N25Qxxx chip specific configuration call-back Lee Jones
2013-12-11 2:33 ` Brian Norris
2013-11-29 12:19 ` [PATCH v3 25/36] mtd: st_spi_fsm: Prepare default sequences for read/write/erase Lee Jones
2013-11-29 12:19 ` [PATCH v3 26/36] mtd: st_spi_fsm: Add the ability to read from a Serial Flash device Lee Jones
2013-12-11 2:09 ` Brian Norris
2013-11-29 12:19 ` [PATCH v3 27/36] mtd: st_spi_fsm: Write to Flash via the FSM FIFO Lee Jones
2013-11-29 12:19 ` [PATCH v3 28/36] mtd: st_spi_fsm: Supply a busy wait for post-write status Lee Jones
2013-12-11 2:13 ` Brian Norris
2013-11-29 12:19 ` [PATCH v3 29/36] mtd: st_spi_fsm: Add the ability to write to a Serial Flash device Lee Jones
2013-11-29 12:19 ` [PATCH v3 30/36] mtd: st_spi_fsm: Erase partly or as a whole " Lee Jones
2013-12-11 2:19 ` Brian Norris
2013-11-29 12:19 ` [PATCH v3 31/36] mtd: st_spi_fsm: Add the ability to read the FSM's status Lee Jones
2013-11-29 12:19 ` [PATCH v3 32/36] mtd: st_spi_fsm: Add the ability to write to FSM's status register Lee Jones
2013-11-29 12:19 ` [PATCH v3 33/36] mtd: st_spi_fsm: Supply the MX25xxx chip specific configuration call-back Lee Jones
2013-12-11 2:25 ` Brian Norris
2013-11-29 12:19 ` [PATCH v3 34/36] mtd: st_spi_fsm: Supply the S25FLxxx " Lee Jones
2013-11-29 12:19 ` [PATCH v3 35/36] mtd: st_spi_fsm: Supply the W25Qxxx " Lee Jones
2013-11-29 12:19 ` [PATCH v3 36/36] ARM: STi: Add support for the FSM Serial Flash Controller Lee Jones
2013-12-02 13:05 ` srinivas kandagatla [this message]
2013-12-02 13:20 ` Lee Jones
2013-12-02 13:26 ` srinivas kandagatla
2013-12-02 13:43 ` Lee Jones
2013-12-02 13:56 ` srinivas kandagatla
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=529C858B.1040601@st.com \
--to=srinivas.kandagatla@st.com \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).