From mboxrd@z Thu Jan 1 00:00:00 1970 From: peppe.cavallaro@st.com (Giuseppe CAVALLARO) Date: Fri, 13 Dec 2013 11:21:56 +0100 Subject: [PATCH 07/10] ARM: dts: sun7i: cubietruck: Enable the GMAC In-Reply-To: References: <1386350983-13281-1-git-send-email-wens@csie.org> <1386350983-13281-8-git-send-email-wens@csie.org> Message-ID: <52AADFC4.1070003@st.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 12/7/2013 2:57 AM, Florian Fainelli wrote: > 2013/12/6 Chen-Yu Tsai : >> On Sat, Dec 7, 2013 at 5:09 AM, Florian Fainelli wrote: >>> 2013/12/6 Chen-Yu Tsai : >>>> The CubieTruck uses the GMAC with an RGMII phy. >>>> >>>> Signed-off-by: Chen-Yu Tsai >>>> --- >>>> arch/arm/boot/dts/sun7i-a20-cubietruck.dts | 8 ++++++++ >>>> 1 file changed, 8 insertions(+) >>>> >>>> diff --git a/arch/arm/boot/dts/sun7i-a20-cubietruck.dts b/arch/arm/boot/dts/sun7i-a20-cubietruck.dts >>>> index 8a1009d..af212a2 100644 >>>> --- a/arch/arm/boot/dts/sun7i-a20-cubietruck.dts >>>> +++ b/arch/arm/boot/dts/sun7i-a20-cubietruck.dts >>>> @@ -33,6 +33,14 @@ >>>> pinctrl-0 = <&uart0_pins_a>; >>>> status = "okay"; >>>> }; >>>> + >>>> + gmac: ethernet at 01c50000 { >>>> + pinctrl-names = "default"; >>>> + pinctrl-0 = <&gmac_pins_rgmii>; >>>> + snps,phy-addr = <1>; >>> >>> What is this snps,phy-addr property? Why is not a standard device tree >>> node for an Ethernet PHY node used? >> >> This property is implemented by stmmac and documented in the DT >> bindings. stmmac has not been updated to use Ethernet PHY nodes. > > This driver property should be removed and deprecated since there is > an ePAPR standardized Ethernet PHY node. What I am worried here is the > loss of information, the standard Ethernet DT node allows to specify > much more information (clause, maximum speed, compatible string > etc...). yes Florian you are right and I have already started updating the driver. I do not sure that I'll be able to send all the patches soon but for sure I can re-base them. >> >> Removing this property will not affect the function of the driver. >> The driver probes its MDIO bus and selects the lowest available >> address if not specified. > > So if this is just giving the driver a hint on where to probe for a > PHY on the MDIO bus, then let's drop it and use the standard DT node > no? > >> >>>> + phy-mode = "rgmii"; >>> >>> Especially since you use the relatively standard "phy-mode" property here? >> >> Used as specified in stmmac DT bindings. > > That one is kind of okay because of_get_phy_mode() knows about it, > even though ePAPR states this should be "phy-connection-type", so I am > okay with keeping that one because current practice and helpers are > here. >