From mboxrd@z Thu Jan 1 00:00:00 1970 From: m.paolino@virtualopensystems.com (Michele Paolino) Date: Thu, 09 Jan 2014 12:22:38 +0100 Subject: [PATCH v4 0/5] USB Host support for OMAP5 uEVM (for 3.14) In-Reply-To: <52CE8314.2000000@ti.com> References: <1389161742-10533-1-git-send-email-rogerq@ti.com> <52CE824D.2090905@virtualopensystems.com> <52CE8314.2000000@ti.com> Message-ID: <52CE867E.1090203@virtualopensystems.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 09/01/2014 12:08, Roger Quadros wrote: > Hi Michele, > > Did you enable CONFIG_USB_EHCI_HCD_OMAP in the kernel config? > It is not enabled by default in omap2plus_defconfig. Indeed it works. Thank you! > > cheers, > -roger > > On 01/09/2014 04:34 PM, Michele Paolino wrote: >> Hello Roger, >> >> I'm testing your patch on an OMAP5430 EVM board. The ethernet is not working in my case. The kernel I'm using is (Tero Kristo's repo - branch 3.13-rc7-dt-clks-v13). Is there something that I'm missing? >> >> Here below you can find more info about my configuration: >> >> boot error messages: >> eth0: ERROR while getting interface flags: No such device >> SIOCSIFADDR: No such device >> eth0: ERROR while getting interface flags: No such device >> SIOCADDRT: Network is unreachable >> >> root at OMAP5:~# /usr/lib/klibc/bin/ipconfig eth0 >> ipconfig: eth0: SIOCGIFINDEX: No such device >> /usr/lib/klibc/bin/ipconfig: no devices to configure >> >> root at OMAP5:~# uname -a >> Linux OMAP5 3.13.0-rc7-g2a4526d-dirty #0 SMP Wed Jan 8 10:41:48 CET 2014x >> >> root at OMAP5:~# dmesg | grep eth >> [ 1.661434] usbcore: registered new interface driver cdc_ether >> >> Regards, >> >> >> On 08/01/2014 07:15, Roger Quadros wrote: >>> Hi Benoit & Tony, >>> >>> This patchset brings up USB Host ports and Ethernet port on >>> the OMAP5 uEVM board. >>> >>> It depends on the TI Clock DT conversion patches [1] and is based >>> on 3.13-rc7 >>> >>> [1] - http://article.gmane.org/gmane.linux.ports.arm.kernel/289895 >>> >>> Changelog: >>> >>> v4: >>> - Updated DT binding document for clock binding >>> >>> v3: >>> - Rebased on top of 3.13-rc7 >>> >>> cheers, >>> -roger >>> >>> Roger Quadros (5): >>> mfd: omap-usb-host: Update DT clock binding information >>> ARM: dts: OMAP5: Add 60MHz clock reference to USB Host module >>> ARM: dts: omap4-panda: Provide USB PHY clock >>> ARM: dts: omap5-uevm: Provide USB PHY clock >>> ARM: OMAP2+: Remove legacy_init_ehci_clk() >>> >>> Documentation/devicetree/bindings/mfd/omap-usb-host.txt | 4 ++++ >>> arch/arm/boot/dts/omap4-panda-common.dtsi | 8 ++------ >>> arch/arm/boot/dts/omap5-uevm.dts | 8 ++------ >>> arch/arm/boot/dts/omap5.dtsi | 2 ++ >>> arch/arm/mach-omap2/pdata-quirks.c | 16 ---------------- >>> 5 files changed, 10 insertions(+), 28 deletions(-) >>> >> >> -- >> *Michele Paolino*, Virtualization R&D Engineer >> Virtual Open Systems >> /Open Source KVM Virtualization Developments/ >> /Multicore Systems Virtualization Porting Services/ >> Web/:/ www.virtualopensystems. com >> >> -- Michele Paolino, Virtualization R&D Engineer Virtual Open Systems