[PATCH 04/04] ARM: shmobile: r8a7790 CCI configuration

[Sudeep.Holla@arm.com (Sudeep Holla)]

Hi,

On 15/01/14 12:26, Magnus Damm wrote:
> From: Gaku Inami <gaku.inami.xw@bp.renesas.com>
> 
> Add the settings of CCI-400 for enabling ca15/ca7 snoop on r8a7790.
> 
> Signed-off-by: Gaku Inami <gaku.inami.xw@bp.renesas.com>
> Signed-off-by: Magnus Damm <damm@opensource.se>
> ---
> 
>  arch/arm/mach-shmobile/smp-r8a7790.c |   15 +++++++++++++++
>  1 file changed, 15 insertions(+)
> 
> --- 0005/arch/arm/mach-shmobile/smp-r8a7790.c
> +++ work/arch/arm/mach-shmobile/smp-r8a7790.c	2014-01-15 15:40:56.000000000 +0900
> @@ -28,6 +28,11 @@
>  #define CA15RESCNT	0x0040
>  #define CA7RESCNT	0x0044
>  #define MERAM		0xe8080000
> +#define CCI_BASE	0xf0090000
> +#define CCI_SLAVE3	0x4000
> +#define CCI_SLAVE4	0x5000
> +#define CCI_SNOOP	0x0000
> +#define CCI_STATUS	0x000c
>  
>  static struct rcar_sysc_ch r8a7790_ca15_scu = {
>  	.chan_offs = 0x180, /* PWRSR5 .. PWRER5 */
> @@ -71,6 +76,16 @@ static void __init r8a7790_smp_prepare_c
>  	r8a7790_pm_init();
>  	rcar_sysc_power_up(&r8a7790_ca15_scu);
>  	rcar_sysc_power_up(&r8a7790_ca7_scu);
> +
> +	/* enable snoop and DVM */
> +	p = ioremap_nocache(CCI_BASE, 0x8000);
> +	writel_relaxed(readl_relaxed(p + CCI_SLAVE3 + CCI_SNOOP) | 0x3,
> +		p + CCI_SLAVE3 + CCI_SNOOP);    /* ca15 */
> +	writel_relaxed(readl_relaxed(p + CCI_SLAVE4 + CCI_SNOOP) | 0x3,
> +		p + CCI_SLAVE4 + CCI_SNOOP);    /* ca7 */
> +	while (__raw_readl(p + CCI_STATUS));
> +	/* wait for pending bit low */
> +	iounmap(p);
>  }

I have mentioned this before, please use drivers/bus/arm-cci.c
That already does the job you need here and you need to use CCI DT bindings
for base address.

Regards,
Sudeep