[PATCH] mmc: dw_mmc: fix dw_mci_get_cd

[zhangfei.gao@linaro.org (zhangfei)]

On 01/15/2014 10:20 PM, Arnd Bergmann wrote:
> On Wednesday 15 January 2014 14:59:59 Arnd Bergmann wrote:
>> On Wednesday 15 January 2014 21:56:26 zhangfei wrote:
>>> However, in our board cd =0 when card is deteced while cd=1 when card is
>>> removed.
>>> In order to mmc_gpio_get_cd return 1, MMC_CAP2_CD_ACTIVE_HIGH has to be
>>> set, as well as new property "caps2-mmc-cd-active-low".
>>>
>>> --- a/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt
>>> +++ b/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt
>>> @@ -73,6 +73,8 @@ Optional properties:
>>> +* caps2-mmc-cd-active-low: cd pin is low when card active
>>> +
>>>
>>> diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
>>> +       if (of_find_property(np, "caps2-mmc-cd-active-low", NULL))
>>> +               pdata->caps2 |= MMC_CAP2_CD_ACTIVE_HIGH;
>>> +
>>
>> The MMC_CAP2_CD_ACTIVE_HIGH flag should only be required for
>> legacy platforms. With DT parsing, you can normally specify
>> the polarity of the GPIO line in the GPIO specifier in DT.
>
> I missed the fact that we already have a "cd-inverted" property
> as specified in bindings/mmc/mmc.txt. If your GPIO controller
> does not handle polarity, you can use that.
>

Thanks Arnd

GPIO controller drivers/gpio/gpio-pl061.c still not handle polarity, so 
use "cd-inverted" instead.