[Linux-kernel] [PATCH 2/3] ARM: shmobile: r8a7790: specify multiple parents for cpg_clks

[ben.dooks@codethink.co.uk (Ben Dooks)]

On 05/02/14 10:32, Laurent Pinchart wrote:
> Hi Ben,
>
> On Wednesday 05 February 2014 09:15:31 Ben Dooks wrote:
>> On 04/02/14 18:17, William Towle wrote:
>>> The current drivers/clk/shmobile/clk-rcar-gen2.c uses the
>>> extal_clk reference for the parent of all the clocks that
>>> it registers. However the lb, qspi, sdh, sd0 and sd1 clocks
>>> are all parented to either pll1 or pll1_div2 which means
>>> that the clock rates are incorrect.
>>>
>>> This is part of the fix that corrects the SDHI0 clock
>>>
>>> rate error where it reports 1MHz instead of 97.5:
>>>       sh_mobile_sdhi ee100000.sd: mmc0 base at 0xee100000 clock rate 1 MHz
>>>
>>> Notes:
>>> - May require cross-merge with clk-rcar-gen2.c fix
>>> - Also not clear which clock "z" is to fix it.
>>
>> Laurent, if you could give us an idea of how to fix this then
>> it would be helpful to get this patch fully fixed.
>
> I've already sent a patch that fixes this issue.
>
> "clk: shmobile: rcar-gen2: Fix clock parent all non-PLL clocks"
>
> (http://www.spinics.net/lists/linux-sh/msg27275.html)
>
> I've just pinged Mike to ask him to pick it up for v3.14.

I just saw and commented on it. I think the DT is the nicer way
of actually doing this, especially if the driver may get re-used
in future.

There's also an issue with SDHI0/1 divider table which has been
posted too.

-- 
Ben Dooks				http://www.codethink.co.uk/
Senior Engineer				Codethink - Providing Genius