[PATCH 0/6] mmc: sdhci-s3c: Fix base clock source management

[tomasz.figa@gmail.com (Tomasz Figa)]

On 20.02.2014 20:26, Tomasz Figa wrote:
> Hi Chris,
>
> On 07.02.2014 10:58, Tomasz Figa wrote:
>> Hi Chris,
>>
>> On 11.01.2014 22:39, Tomasz Figa wrote:
>>> On platforms prior to Exynos the SDHCI block used internal clock
>>> divider controlled by SELFREQ field of CLKCON register to divide base
>>> clock selected from several external clocks fed to the block by
>>> SELBASECLK bitfield of CONTROL2 register. Depending on wanted clock
>>> frequency, different external clock may be the best choice and so
>>> the driver needs to switch the SELBASECLK mux on the fly.
>>>
>>> However the selection logic has been broken for quite some time leaving
>>> the controller using always clock 0, which is not always the right
>>> source and leading to suboptimal performance of the SDHCI block on
>>> affected platforms.
>>>
>>> This series intends to fix the problems mentioned above and also
>>> clean-up
>>> clock management code slightly.
>>>
>>> Tested on S3C6410-based Mini6410 board, with following performance
>>> figures:
>>>
>>> * Before this series (133 MHz HCLK always selected, leading to at most
>>>    33 MHz card clock):
>>>
>>> root at tiny6410:~# hdparm -t /dev/mmcblk0
>>>
>>> /dev/mmcblk0:
>>>   Timing buffered disk reads:  42 MB in  3.10 seconds =  13.54 MB/sec
>>> root at tiny6410:~# hdparm -t /dev/mmcblk0
>>>
>>> /dev/mmcblk0:
>>>   Timing buffered disk reads:  44 MB in  3.11 seconds =  14.14 MB/sec
>>> root at tiny6410:~#
>>>
>>> * After this series (48 MHz EPLL clock selected, leading to 48 MHz card
>>>    clock):
>>>
>>> root at tiny6410:~# hdparm -t /dev/mmcblk0
>>>
>>> /dev/mmcblk0:
>>>   Timing buffered disk reads:  56 MB in  3.04 seconds =  18.41 MB/sec
>>> root at tiny6410:~# hdparm -t /dev/mmcblk0
>>>
>>> /dev/mmcblk0:
>>>   Timing buffered disk reads:  60 MB in  3.06 seconds =  19.63 MB/sec
>>> root at tiny6410:~#
>>>
>>> Tomasz Figa (6):
>>>    mmc: sdhci-s3c: Use shifts to divide by powers of two
>>>    mmc: sdhci-s3c: Cache bus clock rates
>>>    mmc: sdhci-s3c: Use correct condition to check for clock presence
>>>    mmc: sdhci-s3c: Simplify min/max clock calculation
>>>    mmc: sdhci-s3c: Fix handling of bus clock switching
>>>    mmc: sdhci-s3c: Do not allow frequencies higher than requested
>>>
>>>   drivers/mmc/host/sdhci-s3c.c | 170
>>> ++++++++++++++++++++-----------------------
>>>   1 file changed, 77 insertions(+), 93 deletions(-)
>>>
>>
>> What do you think about this series?
>
> Could you take this series for 3.15?

Ping.

It's been almost two months since I posted this series, it's been 
already ACKed and it would be nice to have it applied for upcoming release.

Best regards,
Tomasz