From mboxrd@z Thu Jan 1 00:00:00 1970 From: sergei.shtylyov@cogentembedded.com (Sergei Shtylyov) Date: Thu, 13 Mar 2014 23:53:40 +0300 Subject: [PATCH v2 5/6] ARM: mvebu: Enable NAND controller in Armada 385-DB In-Reply-To: <1394739542-30017-6-git-send-email-ezequiel@vanguardiasur.com.ar> References: <1394739542-30017-1-git-send-email-ezequiel@vanguardiasur.com.ar> <1394739542-30017-6-git-send-email-ezequiel@vanguardiasur.com.ar> Message-ID: <53221AD4.3090002@cogentembedded.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 03/13/2014 10:39 PM, Ezequiel Garcia wrote: > From: Ezequiel Garcia > The Armada 385-DB board has a NAND flash, so enable it in the > devicetree and add the partitions as prepared in the factory images. > Signed-off-by: Ezequiel Garcia > --- > arch/arm/boot/dts/armada-385-db.dts | 21 +++++++++++++++++++++ > 1 file changed, 21 insertions(+) > diff --git a/arch/arm/boot/dts/armada-385-db.dts b/arch/arm/boot/dts/armada-385-db.dts > index 9a13642..edcf7ff 100644 > --- a/arch/arm/boot/dts/armada-385-db.dts > +++ b/arch/arm/boot/dts/armada-385-db.dts > @@ -80,6 +80,27 @@ > reg = <1>; > }; > }; > + > + flash: flash at d0000 { Note that you don't have to label your device the same way as it's named, i.e. you could have labelled it "nand" if it would make things clearer. Although I don't readily see the value of labeling nodes in the board's .dts file. Do you really expect to refer to it somewhere? WBR, Sergei