From mboxrd@z Thu Jan 1 00:00:00 1970 From: sboyd@codeaurora.org (Stephen Boyd) Date: Wed, 11 Jun 2014 12:02:10 -0700 Subject: [PATCH] clocksource: arch_arm_timer: Fix timecounter initialization In-Reply-To: <1402475861-15354-1-git-send-email-Li.Xiubo@freescale.com> References: <1402475861-15354-1-git-send-email-Li.Xiubo@freescale.com> Message-ID: <5398A7B2.6030807@codeaurora.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 06/11/14 01:37, Xiubo Li wrote: > The third parameter(u64 start_tstamp) of timecounter_init() should > be the start time by ns, not a cycle counter. > > Signed-off-by: Xiubo Li > --- > drivers/clocksource/arm_arch_timer.c | 5 +++-- > 1 file changed, 3 insertions(+), 2 deletions(-) > > diff --git a/drivers/clocksource/arm_arch_timer.c b/drivers/clocksource/arm_arch_timer.c > index 5163ec1..6c3cfd8 100644 > --- a/drivers/clocksource/arm_arch_timer.c > +++ b/drivers/clocksource/arm_arch_timer.c > @@ -426,7 +426,7 @@ struct timecounter *arch_timer_get_timecounter(void) > > static void __init arch_counter_register(unsigned type) > { > - u64 start_count; > + u64 start_count, start_ns; > > /* Register the CP15 based counter if we have one */ > if (type & ARCH_CP15_TIMER) > @@ -438,7 +438,8 @@ static void __init arch_counter_register(unsigned type) > clocksource_register_hz(&clocksource_counter, arch_timer_rate); > cyclecounter.mult = clocksource_counter.mult; > cyclecounter.shift = clocksource_counter.shift; > - timecounter_init(&timecounter, &cyclecounter, start_count); > + start_ns = cyclecounter_cyc2ns(&cyclecounter, start_count); > + timecounter_init(&timecounter, &cyclecounter, start_ns); > > /* 56 bits minimum, so we assume worst case rollover */ > sched_clock_register(arch_timer_read_counter, 56, arch_timer_rate); This doesn't make much sense. We're converting start_count, which could be a very large number, into nanoseconds. It looks like we're assuming the counter always starts at 0 which is not always true if you sit in a bootloader for a long time. Perhaps it would be better to just do timecounter_init(&timecounter, &cyclecounter, 0); or timecounter_init(&timecounter, &cyclecounter, ktime_to_ns(ktime_get_real())); -- Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation