From mboxrd@z Thu Jan 1 00:00:00 1970 From: marcin.jabrzyk@gmail.com (Marcin Jabrzyk) Date: Mon, 25 Aug 2014 23:01:10 +0200 Subject: [PATCH 09/11 v4] coresight: adding support for beagle and beagleXM In-Reply-To: References: <1408554231-24321-1-git-send-email-mathieu.poirier@linaro.org> <1408554231-24321-10-git-send-email-mathieu.poirier@linaro.org> <53FA5B55.4000603@gmail.com> Message-ID: <53FBA416.7060406@gmail.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hello, W dniu 25.08.2014 o 16:02, Mathieu Poirier pisze: > On 24 August 2014 15:38, Marcin Jabrzyk wrote: >> Hi, >> >> W dniu 20.08.2014 o 19:03, mathieu.poirier at linaro.org pisze: >>> From: Mathieu Poirier >>> >>> Currently supporting ETM and ETB. Support for TPIU >>> and SDTI are yet to be added. >> Did you tried running the drivers on board or are there any special >> preparation needed? >> I've BeagleBoard-xM Rev. C applied your patches and enabled the >> functions the in menuconfig. >> But on dmesg I see that: >> >> [ 0.685028] of_amba_device_create(): amba_device_add() failed (-19) >> for /etb at 5401b000 >> [ 0.685119] of_amba_device_create(): amba_device_add() failed (-19) >> for /etm at 54010000 >> >> There are no nodes according coresight in /sys/kernel/debug/ . > Right, that is because there is a problem in mainline with enabling > "emu_src_ck". The call to "clk_prepare_enable()" returns without > waiting for the clock to effectively be enabled, preventing the > components from being discovered properly. > > The work around (non-upstreamable) is to have a driver getting a hold > of the clock before AMBA devices are probed. I can send you that code > (10 lines) if need be. Ok I can confirm that this patch works fine for BeagleBoard-xM. After applying workaround for that clock the devices are properly discovered and visible through sysfs entries. Thanks, Marcin > >> Best regards, >> Marcin >> >>> Signed-off-by: Mathieu Poirier >>> --- >>> arch/arm/boot/dts/omap3-beagle-xm.dts | 28 ++++++++++++++++++++++++++++ >>> arch/arm/boot/dts/omap3-beagle.dts | 28 ++++++++++++++++++++++++++++ >>> 2 files changed, 56 insertions(+) >>> >>> diff --git a/arch/arm/boot/dts/omap3-beagle-xm.dts b/arch/arm/boot/dts/omap3-beagle-xm.dts >>> index 1becefc..eec73d8 100644 >>> --- a/arch/arm/boot/dts/omap3-beagle-xm.dts >>> +++ b/arch/arm/boot/dts/omap3-beagle-xm.dts >>> @@ -145,6 +145,34 @@ >>> }; >>> }; >>> }; >>> + >>> + etb at 5401b000 { >>> + compatible = "arm,coresight-etb10", "arm,primecell"; >>> + reg = <0x5401b000 0x1000>; >>> + >>> + coresight-default-sink; >>> + clocks = <&emu_src_ck>; >>> + clock-names = "apb_pclk"; >>> + port { >>> + etb_in: endpoint { >>> + slave-mode; >>> + remote-endpoint = <&etm_out>; >>> + }; >>> + }; >>> + }; >>> + >>> + etm at 54010000 { >>> + compatible = "arm,coresight-etm3x", "arm,primecell"; >>> + reg = <0x54010000 0x1000>; >>> + >>> + clocks = <&emu_src_ck>; >>> + clock-names = "apb_pclk"; >>> + port { >>> + etm_out: endpoint { >>> + remote-endpoint = <&etb_in>; >>> + }; >>> + }; >>> + }; >>> }; >>> >>> &omap3_pmx_wkup { >>> diff --git a/arch/arm/boot/dts/omap3-beagle.dts b/arch/arm/boot/dts/omap3-beagle.dts >>> index 3c3e6da..a151daf 100644 >>> --- a/arch/arm/boot/dts/omap3-beagle.dts >>> +++ b/arch/arm/boot/dts/omap3-beagle.dts >>> @@ -140,6 +140,34 @@ >>> }; >>> }; >>> }; >>> + >>> + etb at 540000000 { >>> + compatible = "arm,coresight-etb10", "arm,primecell"; >>> + reg = <0x5401b000 0x1000>; >>> + >>> + coresight-default-sink; >>> + clocks = <&emu_src_ck>; >>> + clock-names = "apb_pclk"; >>> + port { >>> + etb_in: endpoint { >>> + slave-mode; >>> + remote-endpoint = <&etm_out>; >>> + }; >>> + }; >>> + }; >>> + >>> + etm at 54010000 { >>> + compatible = "arm,coresight-etm3x", "arm,primecell"; >>> + reg = <0x54010000 0x1000>; >>> + >>> + clocks = <&emu_src_ck>; >>> + clock-names = "apb_pclk"; >>> + port { >>> + etm_out: endpoint { >>> + remote-endpoint = <&etb_in>; >>> + }; >>> + }; >>> + }; >>> }; >>> >>> &omap3_pmx_wkup {