[PATCH] mfd: mc13xxx: Configure WDI reset

[philippe.retornaz@gmail.com (Philippe Rétornaz)]

Le 08/09/2014 11:25, Markus Pargmann a ?crit :
> Hi,
>
> On Mon, Sep 08, 2014 at 09:42:35AM +0200, Philippe R?tornaz wrote:
>> Hello
>>
>> Le 08/09/2014 09:01, Markus Pargmann a ?crit :
>>> Setup the PMIC to make a restart when a watchdog interrupt occures.
>>> If this is not configured, the PMIC will shut down the power supply
>>> without a restart.
>>
>>
>> Well, this was used to poweroff the mx31moboard board.
>> So we need to be able to configure the functionality.
>
> So on mx31moboard the watchdog interrupt always leads to a poweroff instead of
> a reset?

Well, no, it simply doesn't work since the output pin is not enabled :)
We enable the watchdog output only in pm_power_off().

> Perhaps it would be better to switch back to poweroff on
> watchdog interrupt right before the shutdown watchdog interrupt is
> triggered.

Yes, we definitely should be doing this.
The only point is that we don't have currently access to the PMIC from 
pm_power_off().
Is there a clean/recommended way to do it ?

Thanks !

Philippe