[PATCH v3 2/3] ARM: shmobile: koelsch: enable HS-USB

[yoshihiro.shimoda.uh@renesas.com (Yoshihiro Shimoda)]

Hello.

(2014/10/09 3:02), Sergei Shtylyov wrote:
> From: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
> 
> Enable HS-USB device for the Koelsch board, defining the GPIO that the driver
> should check when probing (which is the ID output from MAX3355 OTG chip).
> 
> Note that there will be pinctrl-related error messages if both internal PCI
> and HS-USB drivers are enabled but they should be just ignored.
> 
> Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
> [Sergei: added pin function/group and prop, moved device node, fixed summary,
> added changelog]
> Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
> 
> ---
> Changes in version 3:
> - added pinctrl-related properties;
> - moved the HS-USB node to precede the USB PHY node;
> - uppercased "arm" in the summary;
> - added changelog.
> 
>  arch/arm/boot/dts/r8a7791-koelsch.dts |    7 +++++++
>  1 file changed, 7 insertions(+)
> 
> Index: renesas/arch/arm/boot/dts/r8a7791-koelsch.dts
> ===================================================================
> --- renesas.orig/arch/arm/boot/dts/r8a7791-koelsch.dts
> +++ renesas/arch/arm/boot/dts/r8a7791-koelsch.dts
> @@ -464,6 +464,13 @@
>  	pinctrl-names = "default";
>  };
>  
> +&hsusb {
> +	status = "okay";
> +	pinctrl-0 = <&usb0_pins>;
> +	pinctrl-names = "default";

Perhaps I don't understand the pinctrl world yet, but I have a question.

In r8a7791, the USB0_PWEN is GP7_23 and the USB0_OVC is GP7_24. And,
the "usb0_pins" is related to these USB0 pins. But, as you know,
the koelsch has a OTG ID pin and it connects to GP5_31 via MAX3355 chip.
So, would you tell me why koelsch needs the pinctrl?

Best regards,
Yoshihiro Shimoda

> +	renesas,enable-gpio = <&gpio5 31 GPIO_ACTIVE_HIGH>;
> +};
> +
>  &usbphy {
>  	status = "okay";
>  };
>