[PATCHv4 0/3] ARM: dts: Add new board dts file for Exynos3250-based Rinato board

[cw00.choi@samsung.com (Chanwoo Choi)]

Dear Kukjin,

On 10/28/2014 09:19 AM, Kukjin Kim wrote:
> Chanwoo Choi wrote:
>>
>> Dear Kukjin,
>>
> Hi,
> 
>> Did you please pick up this patchset on 3.19 queue?
>>
> I'll apply this series once my previous pull-request which has been sent out
> last week is merged into arm-soc tree.
> 
> If any comments on this series, I'll let you know.
> 

Thanks for applied it.

Best Regards,
Chanwoo Choi

> 
> 
>> Best Regards,
>> Chanwoo Choi
>>
>> On 10/24/2014 10:12 PM, Chanwoo Choi wrote:
>>> This patchset adds new board dts file for Samsung Rinato board (Gear 2) which
>>> is based on Exynos3250 SoC and adds sleep mode pin configuration using pinctrl
>>> subsystem to reduce leakage power-consumption in sleep state.
>>>
>>> This patchset is based on linux-samsung.git (for-next branch).
>>>
>>> Changes from v3:
>>> - Fix wrong email address
>>> - Remove 'vemmc_reg' fixed regulator and then use 'ldo12_reg' for mshc_0
>>>
>>> Changes from v2:
>>> - Separate patch3 from patchset[1] and then this patchset includes patch3.
>>>   After applied patch3, the power-consumption of Rinato board is 0.6mA in suspend state.
>>>   [1] [PATCHv5 0/3] regulator: of: Add support for parsing regulator suspend state
>>>   : https://lkml.org/lkml/2014/10/10/161
>>> - Change PDN (Power-down mode) state for GPE0-3 (BT_UART_RTS) because Rinato
>>>   board uses UART1 for bluetooth device. BT_UART_RTS pin should be disabled in
>>>   suspend state by setting high state of GPE0-3
>>> - Turn on always the regulator state of VAP_VMIPI_1.0V because if VAP_VMIPI_1.0V
>>>   is off state or would be not controlled by DRM driver, happen imprecise external abort.
>>>
>>> Changes from v1:
>>> - Remove useless brace
>>> - Remove unneeded 'regulators' keyword
>>> - Consolidate memory information in one entry
>>>
>>> Chanwoo Choi (3):
>>>   ARM: dts: Add board dts file for Exynos3250-based Rinato board
>>>   ARM: dts: Add sleep mode pin configuration for exynos3250-rinato
>>>   ARM: dts: Add sleep mode of regulator for exynos3250-rinato board
>>>
>>>  arch/arm/boot/dts/Makefile                |   3 +-
>>>  arch/arm/boot/dts/exynos3250-pinctrl.dtsi |  16 +
>>>  arch/arm/boot/dts/exynos3250-rinato.dts   | 686 ++++++++++++++++++++++++++++++
>>>  3 files changed, 704 insertions(+), 1 deletion(-)
>>>  create mode 100644 arch/arm/boot/dts/exynos3250-rinato.dts
>>>
> 
>