[PATCH v3 0/3] Make Armada 375 use the reference clock when possible

[daniel.lezcano@linaro.org (Daniel Lezcano)]

On 11/19/2014 11:45 AM, Wim Van Sebroeck wrote:
> Hi Daniel,
>
> I'll review before the weekend and will let you know something.
> But everything through one tree is fine by me.

Hi Wim,

did you have time to review this patchset ? I would like to send my PR 
for tglx as soon as possible.

Thanks
   -- Daniel

>
> Kind regards,
> Wim.
>
>> On 11/04/2014 02:21 PM, Ezequiel Garcia wrote:
>>> Hi Daniel, Wim:
>>>
>>> Seems we are ready to merge these, unless some objection raises. Do you
>>> think
>>> you can take the patches through your trees?
>>
>> Hi Wim,
>>
>> I can take through my tree the entire patchset if you want but I need
>> your blessing for the watchdog part.
>>
>> Thanks
>>    -- Daniel
>>
>>> Changes from v2:
>>>
>>>    * Fix messed up empty lines, as suggested by Thomas Petazzoni.
>>>
>>> Changes from v1:
>>>
>>>    * Make the A375 timer and watchdog devicetree binding match the hardware
>>>      and require the two available clocks: core and reference clock.
>>>
>>> This series adds support for the 25 MHz reference clock available on
>>> Armada 375 SoC to be used on the timer and watchdog drivers. It is
>>> similar to the one present in Armada XP SoC.
>>>
>>> Given we initially had access to only a very early SoC revision (A375 Z1)
>>> and due to a hardware issue, the timer and watchdog support was originally
>>> submitted to use the core clock.
>>>
>>> Now that the A0 SoC revision is out, we can fix this and use the reference
>>> clock. The reason for this change is that the core clock is subject to the
>>> SSCG (Spread Spectrum Clock Generator), so boards where SSCG is enabled
>>> exhibit a very large timer drift.
>>>
>>> Notice that this change will produce unpleseant results on A375 Z1, given
>>> the
>>> reference 25 MHz clock doesn't work properly on that SoC revision.
>>>
>>> But since the Z1 revision is not supported by the recently submitted A375
>>> network driver (mvpp2), and therefore nobody is expected to run mainline
>>> (if there are users at all of this early revision), the support will be
>>> dropped entirely in a near future.
>>>
>>> To prevent any compatibility issues when booting with an older devicetree,
>>> this series provides proper fall backs in each case.
>>>
>>> The series applies on v3.18-rc2.
>>>
>>> Ezequiel Garcia (3):
>>>    clocksource: armada-370-xp: Add missing clock enable
>>>    watchdog: orion: Use the reference clock on Armada 375 SoC
>>>    clocksource: armada-370-xp: Use the reference clock on A375 SoC
>>>
>>>   .../bindings/timer/marvell,armada-370-xp-timer.txt |  9 +++--
>>>   .../devicetree/bindings/watchdog/marvel.txt        | 13 +++++++
>>>   drivers/clocksource/time-armada-370-xp.c           | 30 ++++++++++++++++
>>>   drivers/watchdog/orion_wdt.c                       | 42
>>>   +++++++++++++++++++++-
>>>   4 files changed, 90 insertions(+), 4 deletions(-)
>>>
>>
>>
>> --
>>   <http://www.linaro.org/> Linaro.org ? Open source software for ARM SoCs
>>
>> Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
>> <http://twitter.com/#!/linaroorg> Twitter |
>> <http://www.linaro.org/linaro-blog/> Blog
>>


-- 
  <http://www.linaro.org/> Linaro.org ? Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog