[PATCH v2] AT91, DT, usb gadget: disable pull-up on vbus-gpio (PB16) to reduce power consumption

[nicolas.ferre@atmel.com (Nicolas Ferre)]

Le 16/01/2015 11:43, Alexandre Belloni a ?crit :
> On 16/01/2015 at 10:50:39 +0100, Sylvain Rochet wrote :
>> There is an external resistor divider on PB16, acting like a pull-down,
>> the pull-up increase power consumption and prevent the vbus detect pin
>> to reach Vss voltage, ~1.5V mesured on my board, it might not even work
>> if the pull-up is stronger than usual.
>>
>> Signed-off-by: Sylvain Rochet <sylvain.rochet@finsecur.com>
> Acked-by: Alexandre Belloni <alexandre.belloni@free-electrons.com>
> 
> You should have added the ack from Bo here too.

Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>

Stacked on top of at91-3.20-dt. Thanks for this patch.

Bye,

>> ---
>> Improved GPIO comment, fixed typo in commit summary.
>>
>>  arch/arm/boot/dts/at91sam9x5ek.dtsi | 9 +++++++++
>>  1 file changed, 9 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/at91sam9x5ek.dtsi b/arch/arm/boot/dts/at91sam9x5ek.dtsi
>> index 3a9f6fa..bd16bd3 100644
>> --- a/arch/arm/boot/dts/at91sam9x5ek.dtsi
>> +++ b/arch/arm/boot/dts/at91sam9x5ek.dtsi
>> @@ -53,6 +53,8 @@
>>  			};
>>  
>>  			usb2: gadget at f803c000 {
>> +				pinctrl-names = "default";
>> +				pinctrl-0 = <&pinctrl_board_usb2>;
>>  				atmel,vbus-gpio = <&pioB 16 GPIO_ACTIVE_HIGH>;
>>  				status = "okay";
>>  			};
>> @@ -80,6 +82,13 @@
>>  							<AT91_PIOD 14 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_UP_DEGLITCH>;	/* PD14 gpio CD pin pull up and deglitch */
>>  					};
>>  				};
>> +
>> +				usb2 {
>> +					pinctrl_board_usb2: usb2-board {
>> +						atmel,pins =
>> +							<AT91_PIOB 16 AT91_PERIPH_GPIO AT91_PINCTRL_DEGLITCH>;		/* PB16 gpio vbus sense, deglitch */
>> +					};
>> +				};
>>  			};
>>  
>>  			spi0: spi at f0000000 {
>> -- 
>> 2.1.4
>>
> 


-- 
Nicolas Ferre