From mboxrd@z Thu Jan  1 00:00:00 1970
From: dinguyen@opensource.altera.com (Dinh Nguyen)
Date: Tue, 31 Mar 2015 09:13:49 -0500
Subject: [RESEND] Altera socfpga big endian work
In-Reply-To: <1427282872-10563-1-git-send-email-ben.dooks@codethink.co.uk>
References: <1427282872-10563-1-git-send-email-ben.dooks@codethink.co.uk>
Message-ID: <551AAB9D.1000809@opensource.altera.com>
To: linux-arm-kernel@lists.infradead.org
List-Id: linux-arm-kernel.lists.infradead.org

Hi Ben,

On 3/25/15 6:27 AM, Ben Dooks wrote:
> This series enables the core of the socfpga systen to run in big endian
> mode. It inclusdes support for debug uart, secondary core boot and has
> support for timers and initial conversion patches for the mmc.
> 
> The two drivers that are known to not work are the Ethernet and the
> dwc2 usb. I do not have data for either, so I currently do not know
> if it possible to change the hardware's endian fetch mode.
> 
> The dwc2 driver on my cyclone5 socfpga board with v4.0-rc5 does not
> work in little endian mode, which makes testing converting the driver
> difficult. The supplied 3.10 kernel does work so it is not down to the
> hardware. It detects the presence of a new device and then fails to
> enumerate it (no other errors shown)
> 
> This is up on git.baserock.org/delta/linux.git in the branch
> baserock/bjdooks/socfpga-v5
> 
> Sorry, this is a resend due to incorrect linux-arm-kernel mailing list
> address.
> 

I think I can take patches 1-3 through my tree, but the mmc patches
[4-7] will need to linux-mmc tree.

Thanks,
Dinh