[RESEND] Altera socfpga big endian work

[ben.dooks@codethink.co.uk (Ben Dooks)]

On 31/03/15 18:47, Dinh Nguyen wrote:
> 
> 
> On 3/31/15 10:34 AM, Ben Dooks wrote:
>> On 31/03/15 15:13, Dinh Nguyen wrote:
>>> Hi Ben,
>>>
>>> On 3/25/15 6:27 AM, Ben Dooks wrote:
>>>> This series enables the core of the socfpga systen to run in big endian
>>>> mode. It inclusdes support for debug uart, secondary core boot and has
>>>> support for timers and initial conversion patches for the mmc.
>>>>
>>>> The two drivers that are known to not work are the Ethernet and the
>>>> dwc2 usb. I do not have data for either, so I currently do not know
>>>> if it possible to change the hardware's endian fetch mode.
>>>>
>>>> The dwc2 driver on my cyclone5 socfpga board with v4.0-rc5 does not
>>>> work in little endian mode, which makes testing converting the driver
>>>> difficult. The supplied 3.10 kernel does work so it is not down to the
>>>> hardware. It detects the presence of a new device and then fails to
>>>> enumerate it (no other errors shown)
>>>>
>>>> This is up on git.baserock.org/delta/linux.git in the branch
>>>> baserock/bjdooks/socfpga-v5
>>>>
>>>> Sorry, this is a resend due to incorrect linux-arm-kernel mailing list
>>>> address.
>>>>
>>>
>>> I think I can take patches 1-3 through my tree, but the mmc patches
>>> [4-7] will need to linux-mmc tree.
>>
>> Thanks. I did CC 4-7 to the relevant maintainers.
>>
>> Any idea if dwc2 is going to be fixed before 4.1?
>>
>>
> 
> I'll have to double check again, but I thought dwc2 on the socfpga has
> been work fine for quite some time now. What are the errors that you are
> seeing?

With 4.0-rc5 it failed to enumerate a USB memory stick attached to
the board. It looked like VCC was supplied. We know the adapter is
working as it comes up under the default boot supplied on the board.

-- 
Ben Dooks				http://www.codethink.co.uk/
Senior Engineer				Codethink - Providing Genius