From: robin.murphy@arm.com (Robin Murphy)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH] iommu/arm-smmu-v2: ThunderX(errata-23399) mis-extends 64bit registers
Date: Thu, 30 Jul 2015 20:08:57 +0100 [thread overview]
Message-ID: <55BA7649.3080608@arm.com> (raw)
In-Reply-To: <20150730184523.GC16663@arm.com>
On 30/07/15 19:45, Will Deacon wrote:
> Hello,
>
> On Thu, Jul 30, 2015 at 06:55:06PM +0100, tchalamarla at caviumnetworks.com wrote:
>> From: Tirumalesh Chalamarla <tchalamarla@caviumnetworks.com>
>>
>> The SMMU architecture defines two different behaviors when 64-bit
>> registers are written with 32-bit writes. The first behavior causes
>> zero extension into the upper 32-bits. The second behavior splits a
>> 64-bit register into "normal" 32-bit register pairs.
>>
>> On some passes of ThunderX,
>> the following registers incorrectly zero extended when they should
>> instead behave as normal 32-bit register pairs:
>>
>> SMMU()_(S)GFAR
>> SMMU()_NSGFAR
>> SMMU()_CB()_TTBR0
>> SMMU()_CB()_TTBR1
>> SMMU()_CB()_FAR
>>
>> Signed-off-by: Tirumalesh Chalamarla <tchalamarla@caviumnetworks.com>
>> ---
>> drivers/iommu/arm-smmu.c | 51 ++++++++++++++++++++++++++++++++++--------------
>> 1 file changed, 36 insertions(+), 15 deletions(-)
>
> [...]
>
>> @@ -762,22 +766,39 @@ static void arm_smmu_init_context_bank(struct arm_smmu_domain *smmu_domain,
>>
>> /* TTBRs */
>> if (stage1) {
>> - reg = pgtbl_cfg->arm_lpae_s1_cfg.ttbr[0];
>> - writel_relaxed(reg, cb_base + ARM_SMMU_CB_TTBR0_LO);
>> - reg = pgtbl_cfg->arm_lpae_s1_cfg.ttbr[0] >> 32;
>> - reg |= ARM_SMMU_CB_ASID(cfg) << TTBRn_HI_ASID_SHIFT;
>> - writel_relaxed(reg, cb_base + ARM_SMMU_CB_TTBR0_HI);
>> -
>> - reg = pgtbl_cfg->arm_lpae_s1_cfg.ttbr[1];
>> - writel_relaxed(reg, cb_base + ARM_SMMU_CB_TTBR1_LO);
>> - reg = pgtbl_cfg->arm_lpae_s1_cfg.ttbr[1] >> 32;
>> - reg |= ARM_SMMU_CB_ASID(cfg) << TTBRn_HI_ASID_SHIFT;
>> - writel_relaxed(reg, cb_base + ARM_SMMU_CB_TTBR1_HI);
>> + if (smmu->options & ARM_SMMU_OPT_64BIT_WRITES_ONLY) {
>> + reg64 = pgtbl_cfg->arm_lpae_s1_cfg.ttbr[0];
>> + reg64 |= ((u64) ARM_SMMU_CB_ASID(cfg)) <<
>> + (TTBRn_HI_ASID_SHIFT + 32);
>> + writeq_relaxed(reg, cb_base + ARM_SMMU_CB_TTBR0_LO);
>> +
>> + reg64 = pgtbl_cfg->arm_lpae_s1_cfg.ttbr[1];
>> + reg64 |= ((u64)ARM_SMMU_CB_ASID(cfg)) <<
>> + (TTBRn_HI_ASID_SHIFT + 32);
>> + writeq_relaxed(reg, cb_base + ARM_SMMU_CB_TTBR1_LO);
>> + } else {
>> + reg = pgtbl_cfg->arm_lpae_s1_cfg.ttbr[0];
>> + writel_relaxed(reg, cb_base + ARM_SMMU_CB_TTBR0_LO);
>> + reg = pgtbl_cfg->arm_lpae_s1_cfg.ttbr[0] >> 32;
>> + reg |= ARM_SMMU_CB_ASID(cfg) << TTBRn_HI_ASID_SHIFT;
>> + writel_relaxed(reg, cb_base + ARM_SMMU_CB_TTBR0_HI);
>> +
>> + reg = pgtbl_cfg->arm_lpae_s1_cfg.ttbr[1];
>> + writel_relaxed(reg, cb_base + ARM_SMMU_CB_TTBR1_LO);
>> + reg = pgtbl_cfg->arm_lpae_s1_cfg.ttbr[1] >> 32;
>> + reg |= ARM_SMMU_CB_ASID(cfg) << TTBRn_HI_ASID_SHIFT;
>> + writel_relaxed(reg, cb_base + ARM_SMMU_CB_TTBR1_HI);
>> + }
>
> I'm fine with making this sort of change if you need it, but this is pretty
> ugly. Worse, it won't compile for 32-bit ARM.
>
> How about we add a wrapper around these, say smmu_writeq(...), which can
> then either expand to 2x writel_relaxed or 1x writeq_relaxed depending on
> CONFIG_64BIT and your erratum workaround?
Would we even need a specific erratum workaround then? I don't see an
issue with always using writeq on 64-bit, and there's not much we can do
for 32-bit if it has no way to write the upper half of the TTBR on this
thing.
Robin.
>
> Don't forgot to update the ATOS code too (so you need to write the high word
> first).
>
> Will
> _______________________________________________
> iommu mailing list
> iommu at lists.linux-foundation.org
> https://lists.linuxfoundation.org/mailman/listinfo/iommu
>
next prev parent reply other threads:[~2015-07-30 19:08 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-07-30 17:55 [PATCH] iommu/arm-smmu-v2: ThunderX(errata-23399) mis-extends 64bit registers tchalamarla at caviumnetworks.com
2015-07-30 18:45 ` Will Deacon
2015-07-30 19:08 ` Robin Murphy [this message]
[not found] ` <96AD8EF9-D416-43AB-BA6F-2C25098BB8BB@caviumnetworks.com>
[not found] ` <91236962-23EF-4306-B0FA-0F7DAE4F06CD@caviumnetworks.com>
2015-07-31 11:27 ` Will Deacon
2015-07-31 11:48 ` Russell King - ARM Linux
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=55BA7649.3080608@arm.com \
--to=robin.murphy@arm.com \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).