From mboxrd@z Thu Jan 1 00:00:00 1970 From: vaibhav.hiremath@linaro.org (Vaibhav Hiremath) Date: Mon, 24 Aug 2015 20:24:10 +0530 Subject: [PATCH-v3 1/2] mfd: devicetree: bindings: 88pm800: Add DT property for dual phase enable In-Reply-To: <20150824130205.GE3237@x1> References: <1440420006-31556-1-git-send-email-vaibhav.hiremath@linaro.org> <1440420006-31556-2-git-send-email-vaibhav.hiremath@linaro.org> <20150824130205.GE3237@x1> Message-ID: <55DB3012.6010904@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Monday 24 August 2015 06:32 PM, Lee Jones wrote: > On Mon, 24 Aug 2015, Vaibhav Hiremath wrote: > >> 88PM860 family of device supports dual phase mode on BUCK1 supply >> providing total 6A capacity. >> Note that by default they operate independently with 3A capacity. >> >> This patch updates the devicetree binding with DT property >> to enable dual-phase mode on BUCK1. >> >> Signed-off-by: Vaibhav Hiremath >> --- >> Documentation/devicetree/bindings/mfd/88pm800.txt | 6 ++++++ >> 1 file changed, 6 insertions(+) >> >> diff --git a/Documentation/devicetree/bindings/mfd/88pm800.txt b/Documentation/devicetree/bindings/mfd/88pm800.txt >> index dec842f..2c82fcb 100644 >> --- a/Documentation/devicetree/bindings/mfd/88pm800.txt >> +++ b/Documentation/devicetree/bindings/mfd/88pm800.txt >> @@ -9,6 +9,12 @@ Required parent device properties: >> - #interrupt-cells : should be 1. >> The cell is the 88pm80x local IRQ number >> >> +Optional properties : >> +- marvell,88pm860-buck1-dualphase-en : If set, enable dual phase on BUCK1, >> + providing 6A capacity. >> + Without this both BUCK1A and BUCK1B operates independently with 3A capacity. >> + (This property is only applicable to 88PM860) > > This will require a Regulator Ack. > > My suggestion would be to remove the 'buck' number, as the same > property could be used on any Buck, and remove the '-en' part, as > this is implied. > Ok, Will do it in next version. Mark, Any comments here before I spin V4. Thanks, Vaibhav