From mboxrd@z Thu Jan 1 00:00:00 1970 From: rjui@broadcom.com (Ray Jui) Date: Fri, 16 Oct 2015 08:36:58 -0700 Subject: [PATCH v2 2/4] mtd: nand: Allow MTD_NAND_BRCMNAND to be selected for ARM64 In-Reply-To: <1444986537-28387-3-git-send-email-anup.patel@broadcom.com> References: <1444986537-28387-1-git-send-email-anup.patel@broadcom.com> <1444986537-28387-3-git-send-email-anup.patel@broadcom.com> Message-ID: <5621199A.1000306@broadcom.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org This patch is the same. I thought it has already been merged by Brian? On 10/16/2015 2:08 AM, Anup Patel wrote: > The BRCM NAND driver can be re-used for Broadcom ARM64 SoCs hence > this patch updates Kconfig to allow selection of MTD_NAND_BRCMNAND > for ARM64. > > Signed-off-by: Anup Patel > Reviewed-by: Vikram Prakash > Reviewed-by: Ray Jui > Reviewed-by: Pramod KUMAR > Reviewed-by: Scott Branden > --- > drivers/mtd/nand/Kconfig | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) > > diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig > index 3324281..a1b5819 100644 > --- a/drivers/mtd/nand/Kconfig > +++ b/drivers/mtd/nand/Kconfig > @@ -393,7 +393,7 @@ config MTD_NAND_GPMI_NAND > > config MTD_NAND_BRCMNAND > tristate "Broadcom STB NAND controller" > - depends on ARM || MIPS > + depends on ARM || ARM64 || MIPS > help > Enables the Broadcom NAND controller driver. The controller was > originally designed for Set-Top Box but is used on various BCM7xxx, >