From mboxrd@z Thu Jan 1 00:00:00 1970 From: caesar.upstream@gmail.com (Caesar Wang) Date: Thu, 22 Oct 2015 11:55:25 +0800 Subject: [RESEND PATCH v2 1/2] dt-bindings: rockchip-thermal: Add the "init" pinctrl in this document In-Reply-To: References: <1445481048-20789-1-git-send-email-wxt@rock-chips.com> <1445481048-20789-2-git-send-email-wxt@rock-chips.com> Message-ID: <56285E2D.2040707@gmail.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org ? 2015?10?22? 11:45, Doug Anderson ??: > Caesar, > > On Wed, Oct 21, 2015 at 7:30 PM, Caesar Wang wrote: >> The "init" pinctrl is defined we'll set >> pinctrl to this state before probe and then "default" after probe. >> >> Add the "init" pinctrl as the OTP gpio state, since we need switch >> the pin to gpio state before the TSADC controller is reset. >> >> As I know, the TSADC controller is reset, the tshut polarity will be >> a *low* signal in a short period of time for some devices. >> >> Says: >> The TSADC get the temperature on rockchip thermal. >> >> If T(current temperature) < (setting temperature), the OTP output the >> *high* signal. >> If T(current temperature) > (setting temperature), the OTP output the >> *low* Signal. >> >> In some cases, the OTP pin is connected to the PMIC, maybe the >> PMIC can accept the reset response time to avoid this issue. >> >> In other words, the system will be always reboot if we make the >> OTP pin is connected the others IC to control the power. >> >> Signed-off-by: Caesar Wang >> Reviewed-by: Douglas Anderson >> --- >> >> Changes in v2: >> - Add the 'init' pinctrl more decription in commit. >> - Fix the subject to make more obvious in PATCH[1/2] >> - Resend this patch v2 since fix the subject to be specific. >> >> Changes in v1: >> - As the Doug comments, add the 'init' property to sync document. >> >> Documentation/devicetree/bindings/thermal/rockchip-thermal.txt | 5 +++-- >> 1 file changed, 3 insertions(+), 2 deletions(-) >> >> diff --git a/Documentation/devicetree/bindings/thermal/rockchip-thermal.txt b/Documentation/devicetree/bindings/thermal/rockchip-thermal.txt >> index ef802de..28e84f7 100644 >> --- a/Documentation/devicetree/bindings/thermal/rockchip-thermal.txt >> +++ b/Documentation/devicetree/bindings/thermal/rockchip-thermal.txt > I think Rob wanted something more in the "rockchip-thermal.txt" > document itself. Like: > > Pinctrl states: > - During device probe a driver may glitch the output line. If this is > not acceptable for your board, you can use the standard "init" and > "default" pinctrl states. The "init" state will be set before device > probe and "default" after. Sound resonable. Thanks Doug to explain! > > _______________________________________________ > Linux-rockchip mailing list > Linux-rockchip at lists.infradead.org > http://lists.infradead.org/mailman/listinfo/linux-rockchip -- Thanks, Caesar