From mboxrd@z Thu Jan 1 00:00:00 1970 From: hdegoede@redhat.com (Hans de Goede) Date: Sun, 22 Nov 2015 12:29:01 +0100 Subject: [linux-sunxi] [PATCH 2/5] phy-sun4i-usb: Add support for the host usb-phys found on the H3 SoC In-Reply-To: <1448048951.1560.5.camel@plaes.org> References: <1447616777-24660-1-git-send-email-hdegoede@redhat.com> <1447616777-24660-2-git-send-email-hdegoede@redhat.com> <1448048951.1560.5.camel@plaes.org> Message-ID: <5651A6FD.3050207@redhat.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi, On 11/20/2015 08:49 PM, Priit Laes wrote: > On Sun, 2015-11-15 at 20:46 +0100, Hans de Goede wrote: >> From: Reinder de Haan >> >> Note this commit only adds support for phys 1-3, phy 0, the otg phy, >> is >> not yet (fully) supported after this commit. > > > This patch seems to be causing following compile warning: > > In file included from include/linux/io.h:25:0, > from drivers/phy/phy-sun4i-usb.c:28: > drivers/phy/phy-sun4i-usb.c: In function 'sun4i_usb_phy_write': ./arch/arm/include/asm/io.h:94:2: warning: 'phyctl' may be used uninitialized in this function [-Wmaybe-uni > nitialized] > asm volatile("strb %1, %0" > ^ > drivers/phy/phy-sun4i-usb.c:172:8: note: 'phyctl' was declared here > void *phyctl; Good catch, thanks the "break;" after the dev_err for the h3 case should be a return (this is a dead code path, the dev_err is there to avoid people trying to actually use sun4i_usb_phy_write() with the h3 in the future). v2 of this patch fixing this is on its way. Regards, Hans > >> >> Signed-off-by: Reinder de Haan >> Signed-off-by: Hans de Goede >> --- >> .../devicetree/bindings/phy/sun4i-usb-phy.txt | 1 + >> drivers/phy/phy-sun4i-usb.c | 67 >> +++++++++++++++++----- >> 2 files changed, 53 insertions(+), 15 deletions(-) >> >> diff --git a/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt >> b/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt >> index 0cebf74..95736d7 100644 >> --- a/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt >> +++ b/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt >> @@ -9,6 +9,7 @@ Required properties: >> * allwinner,sun7i-a20-usb-phy >> * allwinner,sun8i-a23-usb-phy >> * allwinner,sun8i-a33-usb-phy >> + * allwinner,sun8i-h3-usb-phy >> - reg : a list of offset + length pairs >> - reg-names : >> * "phy_ctrl" >> diff --git a/drivers/phy/phy-sun4i-usb.c b/drivers/phy/phy-sun4i- >> usb.c >> index b12964b..17f97ab 100644 >> --- a/drivers/phy/phy-sun4i-usb.c >> +++ b/drivers/phy/phy-sun4i-usb.c >> @@ -46,6 +46,9 @@ >> #define REG_PHYBIST 0x08 >> #define REG_PHYTUNE 0x0c >> #define REG_PHYCTL_A33 0x10 >> +#define REG_PHY_UNK_H3 0x20 >> + >> +#define REG_PMU_UNK_H3 0x10 >> >> #define PHYCTL_DATA BIT(7) >> >> @@ -79,7 +82,7 @@ >> #define PHY_DISCON_TH_SEL 0x2a >> #define PHY_SQUELCH_DETECT 0x3c >> >> -#define MAX_PHYS 3 >> +#define MAX_PHYS 4 >> >> /* >> * Note do not raise the debounce time, we must report Vusb high >> within 100ms >> @@ -88,12 +91,19 @@ >> #define DEBOUNCE_TIME msecs_to_jiffies(50) >> #define POLL_TIME msecs_to_jiffies(250) >> >> +enum sun4i_usb_phy_type { >> + sun4i_a10_phy, >> + sun8i_a33_phy, >> + sun8i_h3_phy >> +}; >> + >> struct sun4i_usb_phy_data { >> + struct device *dev; >> void __iomem *base; >> struct mutex mutex; >> int num_phys; >> u32 disc_thresh; >> - bool has_a33_phyctl; >> + enum sun4i_usb_phy_type type; >> struct sun4i_usb_phy { >> struct phy *phy; >> void __iomem *pmu; >> @@ -164,12 +174,18 @@ static void sun4i_usb_phy_write(struct >> sun4i_usb_phy *phy, u32 addr, u32 data, >> >> mutex_lock(&phy_data->mutex); >> >> - if (phy_data->has_a33_phyctl) { >> + switch (phy_data->type) { >> + case sun4i_a10_phy: >> + phyctl = phy_data->base + REG_PHYCTL_A10; >> + break; >> + case sun8i_a33_phy: >> phyctl = phy_data->base + REG_PHYCTL_A33; >> /* A33 needs us to set phyctl to 0 explicitly */ >> writel(0, phyctl); >> - } else { >> - phyctl = phy_data->base + REG_PHYCTL_A10; >> + break; >> + case sun8i_h3_phy: >> + dev_err(phy_data->dev, "H3 usb_phy_write is not >> supported\n"); >> + break; >> } >> >> for (i = 0; i < len; i++) { >> @@ -230,6 +246,7 @@ static int sun4i_usb_phy_init(struct phy *_phy) >> struct sun4i_usb_phy *phy = phy_get_drvdata(_phy); >> struct sun4i_usb_phy_data *data = >> to_sun4i_usb_phy_data(phy); >> int ret; >> + u32 val; >> >> ret = clk_prepare_enable(phy->clk); >> if (ret) >> @@ -241,15 +258,26 @@ static int sun4i_usb_phy_init(struct phy *_phy) >> return ret; >> } >> >> - /* Enable USB 45 Ohm resistor calibration */ >> - if (phy->index == 0) >> - sun4i_usb_phy_write(phy, PHY_RES45_CAL_EN, 0x01, 1); >> + if (data->type == sun8i_h3_phy) { >> + if (phy->index == 0) { >> + val = readl(data->base + REG_PHY_UNK_H3); >> + writel(val & ~1, data->base + >> REG_PHY_UNK_H3); >> + } >> + >> + val = readl(phy->pmu + REG_PMU_UNK_H3); >> + writel(val & ~2, phy->pmu + REG_PMU_UNK_H3); >> + } else { >> + /* Enable USB 45 Ohm resistor calibration */ >> + if (phy->index == 0) >> + sun4i_usb_phy_write(phy, PHY_RES45_CAL_EN, >> 0x01, 1); >> >> - /* Adjust PHY's magnitude and rate */ >> - sun4i_usb_phy_write(phy, PHY_TX_AMPLITUDE_TUNE, 0x14, 5); >> + /* Adjust PHY's magnitude and rate */ >> + sun4i_usb_phy_write(phy, PHY_TX_AMPLITUDE_TUNE, >> 0x14, 5); >> >> - /* Disconnect threshold adjustment */ >> - sun4i_usb_phy_write(phy, PHY_DISCON_TH_SEL, data- >>> disc_thresh, 2); >> + /* Disconnect threshold adjustment */ >> + sun4i_usb_phy_write(phy, PHY_DISCON_TH_SEL, >> + data->disc_thresh, 2); >> + } >> >> sun4i_usb_phy_passby(phy, 1); >> >> @@ -522,11 +550,14 @@ static int sun4i_usb_phy_probe(struct >> platform_device *pdev) >> mutex_init(&data->mutex); >> INIT_DELAYED_WORK(&data->detect, >> sun4i_usb_phy0_id_vbus_det_scan); >> dev_set_drvdata(dev, data); >> + data->dev = dev; >> >> if (of_device_is_compatible(np, "allwinner,sun5i-a13-usb- >> phy") || >> of_device_is_compatible(np, "allwinner,sun8i-a23-usb- >> phy") || >> of_device_is_compatible(np, "allwinner,sun8i-a33-usb- >> phy")) >> data->num_phys = 2; >> + else if (of_device_is_compatible(np, "allwinner,sun8i-h3- >> usb-phy")) >> + data->num_phys = 4; >> else >> data->num_phys = 3; >> >> @@ -538,13 +569,18 @@ static int sun4i_usb_phy_probe(struct >> platform_device *pdev) >> >> if (of_device_is_compatible(np, "allwinner,sun6i-a31-usb- >> phy") || >> of_device_is_compatible(np, "allwinner,sun8i-a23-usb- >> phy") || >> - of_device_is_compatible(np, "allwinner,sun8i-a33-usb- >> phy")) >> + of_device_is_compatible(np, "allwinner,sun8i-a33-usb- >> phy") || >> + of_device_is_compatible(np, "allwinner,sun8i-h3-usb- >> phy")) >> dedicated_clocks = true; >> else >> dedicated_clocks = false; >> >> if (of_device_is_compatible(np, "allwinner,sun8i-a33-usb- >> phy")) >> - data->has_a33_phyctl = true; >> + data->type = sun8i_a33_phy; >> + else if (of_device_is_compatible(np, "allwinner,sun8i-h3- >> usb-phy")) >> + data->type = sun8i_h3_phy; >> + else >> + data->type = sun4i_a10_phy; >> >> res = platform_get_resource_byname(pdev, IORESOURCE_MEM, >> "phy_ctrl"); >> data->base = devm_ioremap_resource(dev, res); >> @@ -620,7 +656,7 @@ static int sun4i_usb_phy_probe(struct >> platform_device *pdev) >> return PTR_ERR(phy->reset); >> } >> >> - if (i) { /* No pmu for usbc0 */ >> + if (data->type == sun8i_h3_phy || i != 0) { >> snprintf(name, sizeof(name), "pmu%d", i); >> res = platform_get_resource_byname(pdev, >> IORESOURCE_M >> EM, name); >> @@ -696,6 +732,7 @@ static const struct of_device_id >> sun4i_usb_phy_of_match[] = { >> { .compatible = "allwinner,sun7i-a20-usb-phy" }, >> { .compatible = "allwinner,sun8i-a23-usb-phy" }, >> { .compatible = "allwinner,sun8i-a33-usb-phy" }, >> + { .compatible = "allwinner,sun8i-h3-usb-phy" }, >> { }, >> }; >> MODULE_DEVICE_TABLE(of, sun4i_usb_phy_of_match); >> -- >> 2.5.0 >>