From mboxrd@z Thu Jan 1 00:00:00 1970 From: vladimir.murzin@arm.com (Vladimir Murzin) Date: Wed, 25 Nov 2015 14:51:06 +0000 Subject: [RFC PATCH 02/10] clockevents/drivers: add MPS2 Timer driver In-Reply-To: <5655BA34.9040207@linaro.org> References: <1448447621-17900-1-git-send-email-vladimir.murzin@arm.com> <1448447621-17900-3-git-send-email-vladimir.murzin@arm.com> <5655BA34.9040207@linaro.org> Message-ID: <5655CADA.1010803@arm.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi Daniel, Thanks for you review, I agree on all concerns raised and address them in the next version. Just some points to confirm below (I left only relevant parts). >> +static irqreturn_t mps2_timer_interrupt(int irq, void *dev_id) >> +{ >> + struct clockevent_mps2 *ce = dev_id; >> + u32 status = readl(ce->reg + TIMER_INT); >> + >> + if (!status) >> + return IRQ_NONE; > > Why that could happen ? Add a comment. > Sort of defensive programming, I never seen it happens, but just in case of spurious interrupts... Do you prefer to get rid of this check or /* spurious interrupt? */ if (!status) return IRQ_NONE; would be fine to you? >> +} >> + >> +static void __init mps2_timer_init(struct device_node *np) >> +{ >> + static int clksrc; >> + >> + if (!clksrc && !mps2_clocksource_init(np)) >> + clksrc = 1; >> + else >> + mps2_clockevents_init(np); > > That assumes the clocksource is defined before the clockevents in the > DT. If it is not the case, the mps2_clocksource_init will fail (and spit > errors) and mps2_clockevents_init() won't be called. > Does following (stolen from efm32) look better to you? static void __init mps2_timer_init(struct device_node *np) { static int has_clocksource, has_clockevent; int ret; if (!has_clocksource) { ret = mps2_clocksource_init(np); if (!ret) { has_clocksource = 1; return; } } if (!has_clockevent) { ret = mps2_clockevent_init(np); if (!ret) { has_clockevent = 1; return; } } } Thanks Vladimir >> +} >> + >> +CLOCKSOURCE_OF_DECLARE(mps2_timer, "arm,mps2-timer", mps2_timer_init); >> > >