From mboxrd@z Thu Jan 1 00:00:00 1970 From: narmstrong@baylibre.com (Neil Armstrong) Date: Fri, 20 May 2016 10:53:03 +0200 Subject: [PATCH 3/3] ARM64: dts: amlogic: Enable Reset Controller on GXBB-based platforms In-Reply-To: <20160520084748.GC16732@mephisto> References: <1463732875-23141-1-git-send-email-narmstrong@baylibre.com> <1463732875-23141-4-git-send-email-narmstrong@baylibre.com> <20160520084748.GC16732@mephisto> Message-ID: <573ED06F.9070909@baylibre.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 05/20/2016 10:47 AM, Carlo Caione wrote: > On 20/05/16 10:27, Neil Armstrong wrote: >> Update DTSI file to add the reset controller node. >> >> Signed-off-by: Neil Armstrong >> --- >> arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi | 6 ++++++ >> 1 file changed, 6 insertions(+) >> >> diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi b/arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi >> index 832815d..2463e04 100644 >> --- a/arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi >> +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi >> @@ -129,6 +129,12 @@ >> #size-cells = <2>; >> ranges = <0x0 0x0 0x0 0xc1100000 0x0 0x100000>; >> >> + reset: reset-controller at 4404 { >> + compatible = "amlogic,meson-gxbb-reset"; >> + reg = <0x0 0x04404 0x0 0x20>; >> + #reset-cells = <1>; >> + }; >> + >> uart_A: serial at 84c0 { >> compatible = "amlogic,meson-uart"; >> reg = <0x0 0x084c0 0x0 0x14>; > > Missing #include ? > > Thanks, > Shouldn't we wait until the reset bindings are actually used in the dtsi ? I'm quite sure kevin will post it with the Ethernet nodes. Neil