From mboxrd@z Thu Jan 1 00:00:00 1970 From: scott.branden@broadcom.com (Scott Branden) Date: Wed, 22 Jun 2016 10:06:26 -0700 Subject: [PATCH v4 0/3] pwm support for Broadcom iProc SoC's In-Reply-To: <1466594987-26537-1-git-send-email-yendapally.reddy@broadcom.com> References: <1466594987-26537-1-git-send-email-yendapally.reddy@broadcom.com> Message-ID: <576AC592.7030805@broadcom.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi Dhanajaya, Patch series looks good. Acked-by: Scott Branden On 16-06-22 04:29 AM, Yendapally Reddy Dhananjaya Reddy wrote: > This patchset contains the pwm support for the Broadcom's iProc SoC's. > > The first patch provides the documentation details and the > second patch contains the controller support details. The third patch > contains the enable method for Northstar Plus SoC. > > This patch series has been tested on NSP bcm958625HR board. > The pwm is not enabled for this board as the pins are open and not used. > > This patch series is based on v4.7.0-rc1 and is available from github > repo: https://github.com/Broadcom/cygnus-linux.git > branch: iproc-pwm-v4 > > > Changes since v3 > Addressed comments from Scott to include COMPILE_TEST > > Changes since v2 > Rebased on v4.7.0-rc1 > > Changes since v1 > Addressed the review comments from Thierry > 1. Use separate driver for iProc SoC's. > 2. Added Robs ack to the Documentation patch > > Yendapally Reddy Dhananjaya Reddy (3): > Documentation: dt: Add Broadcom iproc pwm controller binding > pwm: iproc: Add support for Broadcom iproc pwm controller > ARM: dts: NSP: Add PWM Support to DT > > .../devicetree/bindings/pwm/brcm,iproc-pwm.txt | 21 ++ > arch/arm/boot/dts/bcm-nsp.dtsi | 8 + > drivers/pwm/Kconfig | 10 + > drivers/pwm/Makefile | 1 + > drivers/pwm/pwm-bcm-iproc.c | 327 +++++++++++++++++++++ > 5 files changed, 367 insertions(+) > create mode 100644 Documentation/devicetree/bindings/pwm/brcm,iproc-pwm.txt > create mode 100644 drivers/pwm/pwm-bcm-iproc.c > Regards, Scott