From mboxrd@z Thu Jan 1 00:00:00 1970 From: guohanjun@huawei.com (Hanjun Guo) Date: Tue, 6 Dec 2016 15:55:40 +0800 Subject: [PATCH] ACPI/IORT: Make dma masks set-up IORT specific In-Reply-To: <20161205122619.25045-1-lorenzo.pieralisi@arm.com> References: <20161205122619.25045-1-lorenzo.pieralisi@arm.com> Message-ID: <58466EFC.3070109@huawei.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 2016/12/5 20:26, Lorenzo Pieralisi wrote: > The introduction of acpi_dma_configure() allows to configure DMA > and related IOMMU for any device that is DMA capable. To achieve > that goal it ensures DMA masks are set-up to sane default values > before proceeding with IOMMU and DMA ops configuration. > > On x86/ia64 systems, through acpi_bind_one(), acpi_dma_configure() is > called for every device that has an ACPI companion, in that every device > is considered DMA capable on x86/ia64 systems (ie acpi_get_dma_attr() API), > which has the side effect of initializing dma masks also for > pseudo-devices (eg CPUs and memory nodes) and potentially for devices > whose dma masks were not set-up before the acpi_dma_configure() API was > introduced, which may have noxious side effects. > > Therefore, in preparation for IORT firmware specific DMA masks set-up, > wrap the default DMA masks set-up in acpi_dma_configure() inside an IORT > specific wrapper that reverts to a NOP on x86/ia64 systems, restoring the > default expected behaviour on x86/ia64 systems and keeping DMA default > masks set-up on IORT based (ie ARM) arch configurations. > > Signed-off-by: Lorenzo Pieralisi > Cc: Will Deacon > Cc: Hanjun Guo Add this patch on top of your v9 acpi smmu patchset, tested on Hisilicon D03 (ARM64), devices with SMMU enabled work fine, Tested-by: Hanjun Guo Reviewed-by: Hanjun Guo Thanks Hanjun