Re: [PATCH v6 1/2] dt-bindings: ufs: Document static TX Equalization settings properties

[Can Guo <can.guo@oss.qualcomm.com>]

On 6/9/2026 3:08 PM, Krzysztof Kozlowski wrote:
> On 31/05/2026 06:48, Can Guo wrote:
>>>>> is the minimal encoding that covers both.
>>>> Again, why do you need to encode '0'?
>>> The tuple is still needed because Precoding is configured per
>>> transmitter-receiver pair,
>>> so each lane has two independent states:
>>> - Host_TX -> Device_RX
>>> - Device_TX -> Host_RX
>>> A lane-only enabled list cannot represent directional combinations
>>> like lane0 =
>>> (on, off) vs (off, on).
>> How about we split into two properties, something like below?
>> tx-precode-enable-g6-host-lanes = <0 1>
>> tx-precode-enable-g6-device-lanes = <1>
>>
>> Only listed lanes are enabled; unlisted lanes are disabled by default.
>>
>> Are you OK with this approach?
> Yes, I do prefer this, because we don't have empty entries (<0, 0>, <0,
> 1> ....).
Thank you for coming back. Sure, I will use this format in next version.

Best Regards,
Can Guo.
>
> Best regards,
> Krzysztof