[PATCH] v4l: omap4iss: Replace outdated OMAP4 control pad API with syscon

[laurent.pinchart@ideasonboard.com (Laurent Pinchart)]

Hi Sakari,

Thank you for the review.

On Sunday 12 April 2015 17:31:09 Sakari Ailus wrote:
> On Sun, Apr 12, 2015 at 03:28:13PM +0300, Laurent Pinchart wrote:
> > diff --git a/drivers/staging/media/omap4iss/iss_csiphy.c
> > b/drivers/staging/media/omap4iss/iss_csiphy.c index 7c3d55d..748607f
> > 100644
> > --- a/drivers/staging/media/omap4iss/iss_csiphy.c
> > +++ b/drivers/staging/media/omap4iss/iss_csiphy.c
> > @@ -13,6 +13,7 @@
> > 
> >  #include <linux/delay.h>
> >  #include <linux/device.h>
> > +#include <linux/regmap.h>
> > 
> >  #include "../../../../arch/arm/mach-omap2/control.h"
> > 
> > @@ -140,9 +141,11 @@ int omap4iss_csiphy_config(struct iss_device *iss,
> >  	 * - bit [18] : CSIPHY1 CTRLCLK enable
> >  	 * - bit [17:16] : CSIPHY1 config: 00 d-phy, 01/10 ccp2
> >  	 */
> > -	cam_rx_ctrl = omap4_ctrl_pad_readl(
> > -			OMAP4_CTRL_MODULE_PAD_CORE_CONTROL_CAMERA_RX);
> > -
> > +	/*
> > +	 * TODO: When implementing DT support specify the CONTROL_CAMERA_RX
> > +	 * register offset in the syscon property instead of hardcoding it.
> > +	 */
> > +	regmap_read(iss->syscon, 0x68, &cam_rx_ctrl);
> 
> Do you use platform data now? I guess the address is the same on all SoCs
> that use the OMAP 4 ISS?

Yes I use platform data for now. The address is the same on all SoCs on which 
I've tested the driver, which is a single SoC :-) I'll research that when 
implementing DT bindings.

> Acked-by: Sakari Alius <sakari.ailus@iki.fi>

Thank you.

-- 
Regards,

Laurent Pinchart