From mboxrd@z Thu Jan 1 00:00:00 1970 From: michal.simek@xilinx.com (Michal Simek) Date: Wed, 10 Oct 2018 09:25:24 +0200 Subject: [PATCH 6/6] arm64: dts: xilinx: ultra96: Standardize LED labels and triggers In-Reply-To: <20181009140522.6492-7-manivannan.sadhasivam@linaro.org> References: <20181009140522.6492-1-manivannan.sadhasivam@linaro.org> <20181009140522.6492-7-manivannan.sadhasivam@linaro.org> Message-ID: <7b94c09d-ecbd-e48e-6583-127566715a76@xilinx.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 9.10.2018 16:05, Manivannan Sadhasivam wrote: > For all 96Boards, the following standard is used for onboard LEDs. > > device-name:green:user1 default-trigger: heartbeat > device-name:green:user2 default-trigger: mmc0/disk-activity > (onboard-storage) > device-name:green:user3 default-trigger: mmc1 (SD-card) > device-name:green:user4 default-trigger: none, panic-indicator > device-name:yellow:wlan default-trigger: phy0tx > device-name:blue:bt default-trigger: hci0-power > > So lets adopt the same for Ultra96, which is one of the 96Boards > CE and AI platform. Since the WLAN and BT LEDs are hardwired onboard, > consolidate only User LEDs. > > Signed-off-by: Manivannan Sadhasivam > --- > arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts | 15 ++++++++------- > 1 file changed, 8 insertions(+), 7 deletions(-) > > diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts > index eb5e8bddb610..565ceb390f99 100644 > --- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts > +++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts > @@ -57,29 +57,30 @@ > leds { > compatible = "gpio-leds"; > ds2 { > - label = "ds2"; > + label = "zynqmp-zcu100-revC:green:user1"; The purpose of this series should be standardize Led labels that's why I would expect that leds will be called in the same way on all these boards that's why I am not getting why there is board name. green:user1 or just user1 should be enough. Thanks, Michal