Re: [PATCH v5 3/3] arm64: dts: cix: Add USB4/USB5 nodes for Sky1

[Krzysztof Kozlowski <krzk@kernel.org>]

On 03/11/2026 08:49, Hongliang Yang (杨宏亮) wrote:
> Add USB4 and USB5 controller nodes for the CIX Sky1 SoC. Enable USB4
> and USB5 in host mode on the Radxa Orion O6 board.
> 
> The two controllers share the RCSU register region and their glue
> registers are interleaved inside it, so the region is described by a
> simple-bus container with an address-translating ranges property and
> each controller maps its registers as offsets inside that region.
> 
> Signed-off-by: Hongliang Yang <hongliang.yang@cixtech.com>
> ---
> v4 -> v5:
> - Fixed continuation line indentation reported by checkpatch.
>  arch/arm64/boot/dts/cix/sky1-orion-o6.dts | 42 ++++++++++
>  arch/arm64/boot/dts/cix/sky1.dtsi         | 95 +++++++++++++++++++++++
>  2 files changed, 137 insertions(+)
> 

No improvements, since v2. You never responded to feedback, never asked
for clarifications, just ignored it. At v4 I tried to explain it more,
you did not respond.

NAK.

Best regards,
Krzysztof