From mboxrd@z Thu Jan 1 00:00:00 1970 From: j-keerthy@ti.com (Keerthy) Date: Tue, 12 Dec 2017 13:52:19 +0530 Subject: [PATCH v5 1/8] clocksource: dmtimer: Remove all the exports In-Reply-To: <20171212081923.GA10084@lenoch> References: <1513059137-21593-1-git-send-email-j-keerthy@ti.com> <1513059137-21593-2-git-send-email-j-keerthy@ti.com> <20171212071624.GA3453@lenoch> <20171212080134.GA9589@lenoch> <9de9b3dc-09f4-d58b-ba5a-60fcb563c665@ti.com> <20171212081923.GA10084@lenoch> Message-ID: <7c92b0c2-8784-9c14-66b0-a19fe68f08ad@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Tuesday 12 December 2017 01:49 PM, Ladislav Michl wrote: > On Tue, Dec 12, 2017 at 01:38:04PM +0530, Keerthy wrote: >> On Tuesday 12 December 2017 01:31 PM, Ladislav Michl wrote: >>> On Tue, Dec 12, 2017 at 01:01:51PM +0530, Keerthy wrote: >>>> >>>> >>>> On Tuesday 12 December 2017 12:46 PM, Ladislav Michl wrote: >>>>> Keerthy, >>>>> >>>>> On Tue, Dec 12, 2017 at 11:42:10AM +0530, Keerthy wrote: >>>>>> Remove all the unwanted exports from the driver >>>>> >>>>> I'm adding event capture capability to the pwm-omap driver and so far used >>>>> v4.15-rc3 as codebase. >>>>> >>>>> Intended use is an IR receiver; for that I need to measure pulses width and >>>>> spaces between pulses. So DM timer was setup to generate interupt after >>>>> both TCAR1 and TCAR2 are filled, values are passed to IR decoder and >>>>> TCAR_IT_FLAG is cleared. >>>>> >>>>> Of course, this is just proof of concept and needs to be polished and >>>>> generalized, but to make it at least work I need functions you just >>>>> unexported (plus some new). >>>>> >>>>> Question is whenever we need this level of indirection (omap_dm_timer_ops) >>>>> or plain exports are enough. >>>> >>>> The general guidance is not to do plain exports and go via >>>> omap_dm_timer_ops. >>> >>> ...in contrary what other clocksource drivers are doing. >>> >>> Now I'm assuming it is okay to extend omap_dm_timer_ops. That would mean >>> check for ops members to be assigned should be also extended or we should >>> delete it altogether and assume all members are populated? >> >> It should be fine to extend omap_dm_timer_ops. What are the ops missing >> for your new implementation? > > Read capture registers, configure capture and ack interrupt. Perhaps set_pwm > could be extended to configure capture as well. > > I'll update my code on top of your changes and we'll see how it would work. Okay Thanks! > >> Tony, >> >> Your thoughts on the above? >> >> R