From: khilman@baylibre.com (Kevin Hilman)
To: linux-arm-kernel@lists.infradead.org
Subject: [GIT PULL] Amlogic 64-bit DT updates for v4.15
Date: Sun, 22 Oct 2017 03:41:25 -0700 [thread overview]
Message-ID: <7hefpvqxbe.fsf@baylibre.com> (raw)
Arnd, Olof,
Note that this PR is against v4.14-rc4 because of dependencies on some
Amlogic DT64 changes that missed next/late and ended up going in as
fixes and landed in -rc4.
Kevin
The following changes since commit 8a5776a5f49812d29fe4b2d0a2d71675c3facf3f:
Linux 4.14-rc4 (2017-10-08 20:53:29 -0700)
are available in the git repository at:
git://git.kernel.org/pub/scm/linux/kernel/git/khilman/linux-amlogic.git tags/amlogic-dt64
for you to fetch changes up to 9d59b708500fcb62d28e15b8c6333be620984d8b:
arm64: dts: meson-axg: add initial A113D SoC DT support (2017-10-19 03:17:07 -0700)
----------------------------------------------------------------
Amlogic 64-bit platforms: DT updates for v4.15
- new SoC support: A113D
- new boards: Tronsmart Vega S96, Khadas vim2
- reserved memory fixups
- gpio-names cleanups
- MMC cleanups, enable high-speed modes
- misc cleanups
----------------------------------------------------------------
Jerome Brunet (10):
ARM64: dts: meson-gxl-libretech-cc: enable saradc
ARM64: dts: meson-gxl-libretech-cc: enable internal phy leds
ARM: dts: meson8: remove gpio offset
ARM64: dts: meson-gx: remove gpio offset
ARM64: dts: meson-gx: adjust gpio-ranges for TEST_N
ARM64: dts: meson-gxbb: adjust nanopi-k2 gpio-line-names
ARM64: dts: meson-gxbb: adjust odroid-c2 gpio-line-names
ARM64: dts: meson-gxl: adjust kvim gpio-line-names
ARM64: dts: meson-gxl: adjust libretech-cc gpio-line-names
ARM64: dts: meson-gxm: enable HS400 on the vim2
Neil Armstrong (7):
ARM64: dts: meson-gxl: Take eMMC data strobe out of eMMC pins
ARM64: dts: meson-gxm: Add support for Khadas VIM2
ARM64: dts: meson-gxm: Add Vega S96 board
dt-bindings: arm: amlogic: Add Tronsmart Vega S96 binding
ARM64: dts: meson-gxl: Add alternate ARM Trusted Firmware reserved memory zone
ARM64: dts: meson-gx: remove unnecessary clocks properties
ARM64: dts: meson-gx: remove unnecessary uart compatible
Peter Korsgaard (1):
ARM64: dts: meson-gxbb-nexbox-a95x: Enable USB Nodes
Yixun Lan (2):
dt-bindings: arm: amlogic: Add Meson AXG binding
arm64: dts: meson-axg: add initial A113D SoC DT support
Documentation/devicetree/bindings/arm/amlogic.txt | 8 ++
arch/arm/boot/dts/meson8.dtsi | 2 +-
arch/arm/boot/dts/meson8b.dtsi | 2 +-
arch/arm64/boot/dts/amlogic/Makefile | 3 +
arch/arm64/boot/dts/amlogic/meson-axg-s400.dts | 22 ++++++
arch/arm64/boot/dts/amlogic/meson-axg.dtsi | 204 +++++++++++++++++++++++++++++++++++++++++++++++++
arch/arm64/boot/dts/amlogic/meson-gx-p23x-q20x.dtsi | 2 +-
arch/arm64/boot/dts/amlogic/meson-gx.dtsi | 13 ++--
arch/arm64/boot/dts/amlogic/meson-gxbb-nanopi-k2.dts | 12 +--
arch/arm64/boot/dts/amlogic/meson-gxbb-nexbox-a95x.dts | 31 +++++++-
arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts | 12 +--
arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi | 2 +-
arch/arm64/boot/dts/amlogic/meson-gxbb-vega-s95.dtsi | 2 +-
arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi | 12 ++-
arch/arm64/boot/dts/amlogic/meson-gxl-s905x-hwacom-amazetv.dts | 2 +-
arch/arm64/boot/dts/amlogic/meson-gxl-s905x-khadas-vim.dts | 8 +-
arch/arm64/boot/dts/amlogic/meson-gxl-s905x-libretech-cc.dts | 27 +++++--
arch/arm64/boot/dts/amlogic/meson-gxl-s905x-nexbox-a95x.dts | 2 +-
arch/arm64/boot/dts/amlogic/meson-gxl-s905x-p212.dtsi | 2 +-
arch/arm64/boot/dts/amlogic/meson-gxl.dtsi | 20 ++++-
arch/arm64/boot/dts/amlogic/meson-gxm-khadas-vim2.dts | 400 +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
arch/arm64/boot/dts/amlogic/meson-gxm-nexbox-a1.dts | 2 +-
arch/arm64/boot/dts/amlogic/meson-gxm-rbox-pro.dts | 2 +-
arch/arm64/boot/dts/amlogic/meson-gxm-vega-s96.dts | 38 ++++++++++
24 files changed, 784 insertions(+), 46 deletions(-)
create mode 100644 arch/arm64/boot/dts/amlogic/meson-axg-s400.dts
create mode 100644 arch/arm64/boot/dts/amlogic/meson-axg.dtsi
create mode 100644 arch/arm64/boot/dts/amlogic/meson-gxm-khadas-vim2.dts
create mode 100644 arch/arm64/boot/dts/amlogic/meson-gxm-vega-s96.dts
next reply other threads:[~2017-10-22 10:41 UTC|newest]
Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-10-22 10:41 Kevin Hilman [this message]
2017-10-30 13:36 ` [GIT PULL] Amlogic 64-bit DT updates for v4.15 Arnd Bergmann
2017-10-30 16:55 ` Kevin Hilman
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=7hefpvqxbe.fsf@baylibre.com \
--to=khilman@baylibre.com \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).