From mboxrd@z Thu Jan 1 00:00:00 1970 From: gregory.clement@free-electrons.com (Gregory CLEMENT) Date: Tue, 03 Jan 2017 16:14:52 +0100 Subject: [PATCH v4 4/4] arm64: dts: marvell: Enable spi0 on the board Armada-3720-db In-Reply-To: <20161208145847.7794-5-romain.perier@free-electrons.com> (Romain Perier's message of "Thu, 8 Dec 2016 15:58:47 +0100") References: <20161208145847.7794-1-romain.perier@free-electrons.com> <20161208145847.7794-5-romain.perier@free-electrons.com> Message-ID: <87a8b8gopf.fsf@free-electrons.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi Romain, On jeu., d?c. 08 2016, Romain Perier wrote: > This commit enables the device node spi0 on the official development > board for the Marvell Armada 3700. It also adds sub-node for the 128Mb > SPI-NOR present on the board. > > Signed-off-by: Romain Perier > Tested-by: Gregory CLEMENT Applied on mvebu/dt64 Thanks, Gregory > --- > > Changes in v3: > - Added tag "Tested-by" by Gregory > > arch/arm64/boot/dts/marvell/armada-3720-db.dts | 30 ++++++++++++++++++++++++++ > 1 file changed, 30 insertions(+) > > diff --git a/arch/arm64/boot/dts/marvell/armada-3720-db.dts b/arch/arm64/boot/dts/marvell/armada-3720-db.dts > index 1372e9a6..0c4eb98 100644 > --- a/arch/arm64/boot/dts/marvell/armada-3720-db.dts > +++ b/arch/arm64/boot/dts/marvell/armada-3720-db.dts > @@ -67,6 +67,36 @@ > status = "okay"; > }; > > +&spi0 { > + status = "okay"; > + > + m25p80 at 0 { > + compatible = "jedec,spi-nor"; > + reg = <0>; > + spi-max-frequency = <108000000>; > + spi-rx-bus-width = <4>; > + spi-tx-bus-width = <4>; > + > + partitions { > + compatible = "fixed-partitions"; > + #address-cells = <1>; > + #size-cells = <1>; > + partition at 0 { > + label = "bootloader"; > + reg = <0x0 0x200000>; > + }; > + partition at 200000 { > + label = "U-boot Env"; > + reg = <0x200000 0x10000>; > + }; > + partition at 210000 { > + label = "Linux"; > + reg = <0x210000 0xDF0000>; > + }; > + }; > + }; > +}; > + > /* Exported on the micro USB connector CON32 through an FTDI */ > &uart0 { > status = "okay"; > -- > 2.9.3 > -- Gregory Clement, Free Electrons Kernel, drivers, real-time and embedded Linux development, consulting, training and support. http://free-electrons.com