[PATCH 2/2] OMAP2+: PM: SR: add suspend/resume handlers

[khilman@ti.com (Kevin Hilman)]

Nishanth Menon <nm@ti.com> writes:

> Suspend and Resume paths are safe enough to do it in

What is 'it'  ?

> the standard LDM suspend/resume handlers where one can
> sleep. Add suspend/resume handlers for SmartReflex.

Minor comments on the code below, but this changelog doesn't read well,
or at least I can't make any sense of it.

[...]

> @@ -684,6 +685,12 @@ void omap_sr_enable(struct voltagedomain *voltdm)
>  	if (!sr->autocomp_active)
>  		return;
>  
> +	if (sr->is_suspended) {
> +		dev_dbg(&sr->pdev->dev, "%s: in suspended state\n", __func__);
> +		return;
> +	}
> +
> +

extra blank line

>  	if (!sr_class || !(sr_class->enable) || !(sr_class->configure)) {
>  		dev_warn(&sr->pdev->dev, "%s: smartreflex class driver not"
>  			"registered\n", __func__);

[...]

>  static struct platform_driver smartreflex_driver = {
>  	.remove         = omap_sr_remove,
> +	.suspend	= omap_sr_suspend,
> +	.resume		= omap_sr_resume,

You're using the legacy methods here, please use dev_pm_ops.

That means you'll need to create a struct dev_pm_ops and fill in these
mehods there (and note the dev_pm_ops methods don't have a 'state'
argument.

Also, when implementing suspend/resume, you need to make sure the
hibernate callbacks are populated also.  They should be populated with
the same callbacks, so the best way to do this is to use
SIMPLE_DEV_PM_OPS() (see <linux/pm.h>).  That macro also takes care of
the !CONFIG_PM case as well.

IOW, the result would look someting like this (not even compile tested):

static SIMPLE_DEV_PM_OPS(omap_sr_pm_ops, omap_sr_suspend, omap_sr_resume)

static struct platform_driver smartreflex_driver = {
	.remove         = omap_sr_remove,
	.driver		= {
		.name	= "smartreflex",
                .pm     = &omap_sr_pm_ops,
	},
};

Kevin