* [PATCH v2] irqchip/irq-brcmstb-l2: add write memory barrier before exit
@ 2024-02-10 1:24 Florian Fainelli
2024-02-10 9:32 ` Marc Zyngier
0 siblings, 1 reply; 2+ messages in thread
From: Florian Fainelli @ 2024-02-10 1:24 UTC (permalink / raw)
To: linux-kernel
Cc: maz, Doug Berger, Florian Fainelli,
Broadcom internal kernel review list, Thomas Gleixner,
Brian Norris, Jason Cooper,
open list:BROADCOM BMIPS MIPS ARCHITECTURE,
moderated list:BROADCOM BCM7XXX ARM ARCHITECTURE
From: Doug Berger <opendmb@gmail.com>
It was observed on Broadcom devices that use GIC v3 architecture
L1 interrupt controllers as the parent of brcmstb-l2 interrupt
controllers that the deactivation of the parent irq could happen
before the brcmstb-l2 deasserted its output. This would lead the
GIC to reactivate the irq only to find that no L2 interrupt was
pending. The result was a spurious interrupt invoking the
handle_bad_irq() with its associated messaging. While this did
not create a functional problem it is a waste of cycles.
The hazard exists because the memory mapped bus writes to the
brcmstb-l2 registers are buffered and the GIC v3 architecture
uses a very efficient system register write to deactivate the
interrupt. This commit adds a write memory barrier prior to
invoking chained_irq_exit() to introduce a dsb(st) on those
systems to ensure the system register write cannot be executed
until the memory mapped writes are visible to the system.
Signed-off-by: Doug Berger <opendmb@gmail.com>
Acked-by: Florian Fainelli <florian.fainelli@broadcom.com>
Fixes: 7f646e92766e ("irqchip: brcmstb-l2: Add Broadcom Set Top Box Level-2 interrupt controller")
[florian: Added Fixes tag]
Signed-off-by: Florian Fainelli <florian.fainelli@broadcom.com>
---
Changes in v2:
- add Fixes tag
- bump copyright
drivers/irqchip/irq-brcmstb-l2.c | 5 ++++-
1 file changed, 4 insertions(+), 1 deletion(-)
diff --git a/drivers/irqchip/irq-brcmstb-l2.c b/drivers/irqchip/irq-brcmstb-l2.c
index 5559c943f03f..63aed60dd3f1 100644
--- a/drivers/irqchip/irq-brcmstb-l2.c
+++ b/drivers/irqchip/irq-brcmstb-l2.c
@@ -2,7 +2,7 @@
/*
* Generic Broadcom Set Top Box Level 2 Interrupt controller driver
*
- * Copyright (C) 2014-2017 Broadcom
+ * Copyright (C) 2014-2024 Broadcom
*/
#define pr_fmt(fmt) KBUILD_MODNAME ": " fmt
@@ -112,6 +112,9 @@ static void brcmstb_l2_intc_irq_handle(struct irq_desc *desc)
generic_handle_domain_irq(b->domain, irq);
} while (status);
out:
+ /* Don't ack parent before all device writes are done */
+ wmb();
+
chained_irq_exit(chip, desc);
}
--
2.34.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
^ permalink raw reply related [flat|nested] 2+ messages in thread
* Re: [PATCH v2] irqchip/irq-brcmstb-l2: add write memory barrier before exit
2024-02-10 1:24 [PATCH v2] irqchip/irq-brcmstb-l2: add write memory barrier before exit Florian Fainelli
@ 2024-02-10 9:32 ` Marc Zyngier
0 siblings, 0 replies; 2+ messages in thread
From: Marc Zyngier @ 2024-02-10 9:32 UTC (permalink / raw)
To: Florian Fainelli
Cc: linux-kernel, Doug Berger, Broadcom internal kernel review list,
Thomas Gleixner, Brian Norris, Jason Cooper,
open list:BROADCOM BMIPS MIPS ARCHITECTURE,
moderated list:BROADCOM BCM7XXX ARM ARCHITECTURE
On Sat, 10 Feb 2024 01:24:49 +0000,
Florian Fainelli <florian.fainelli@broadcom.com> wrote:
>
> From: Doug Berger <opendmb@gmail.com>
>
> It was observed on Broadcom devices that use GIC v3 architecture
> L1 interrupt controllers as the parent of brcmstb-l2 interrupt
> controllers that the deactivation of the parent irq could happen
> before the brcmstb-l2 deasserted its output. This would lead the
> GIC to reactivate the irq only to find that no L2 interrupt was
> pending. The result was a spurious interrupt invoking the
> handle_bad_irq() with its associated messaging. While this did
> not create a functional problem it is a waste of cycles.
>
> The hazard exists because the memory mapped bus writes to the
> brcmstb-l2 registers are buffered and the GIC v3 architecture
> uses a very efficient system register write to deactivate the
> interrupt. This commit adds a write memory barrier prior to
> invoking chained_irq_exit() to introduce a dsb(st) on those
> systems to ensure the system register write cannot be executed
> until the memory mapped writes are visible to the system.
>
> Signed-off-by: Doug Berger <opendmb@gmail.com>
> Acked-by: Florian Fainelli <florian.fainelli@broadcom.com>
> Fixes: 7f646e92766e ("irqchip: brcmstb-l2: Add Broadcom Set Top Box Level-2 interrupt controller")
> [florian: Added Fixes tag]
> Signed-off-by: Florian Fainelli <florian.fainelli@broadcom.com>
Acked-by: Marc Zyngier <maz@kernel.org>
M.
--
Without deviation from the norm, progress is not possible.
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
^ permalink raw reply [flat|nested] 2+ messages in thread
end of thread, other threads:[~2024-02-10 9:32 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2024-02-10 1:24 [PATCH v2] irqchip/irq-brcmstb-l2: add write memory barrier before exit Florian Fainelli
2024-02-10 9:32 ` Marc Zyngier
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).